Operating Instructions No. 705-2 USA
Operating Instructions No. 705-2 USA
Operating Instructions No. 705-2 USA
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
3. Adjusting the swather<br />
• Only carry out repairs, maintenance/ cleaning work and troubleshooting when the drive is<br />
switched off and the engine is at a standstill. – Remove the ignition key.<br />
• The swather is designed for a PTO speed of max. 540 r.p.m.<br />
• Recommended PTO shaft operating speed 350 - 450 r.p.m.<br />
• The rotary swather should not be driven with a PTO speed of 1000 r.p.m. under ANY<br />
circumstances.<br />
3.1 Basic setting<br />
Slowly lower the swather. Set the tractor lower link arm<br />
to “lower” so that the bearing bolt (1) lays on the three<br />
point frame guide. Set the tractor top link arm so that the<br />
swather is horizontal to slightly angled forward and so<br />
that the tines are slightly touching the ground.<br />
1<br />
2<br />
KS200050<br />
3.2 Installing and removing the tine bars<br />
Before installing and removing the tine<br />
bars, be it for operation or transport, it<br />
must be ensured that any unintentional<br />
operation of pull rope (1) for unlocking<br />
the safety frames is excluded. Danger of<br />
accident!<br />
Installation<br />
• Withdraw the linch pins (1) from the tine bars.<br />
• Remove the tine bars (2) from transport rack (3) and<br />
slide them over the coupling arms of the rotor.<br />
• Lock the tine bars (2) using the linch pins (1).<br />
3<br />
2<br />
1<br />
KS200038<br />
2<br />
Removal<br />
• Withdraw the linch pins (1).<br />
• Remove the tine bars (2) from the coupling arms and<br />
lock them in their transport rack (3) located on the<br />
carrier frame. Make sure that the tines face the<br />
inside.<br />
• Lock the tine bars (2) using the linch pins (1).<br />
1<br />
KS200039<br />
16