Untitled - bei Regulus GmbH
Untitled - bei Regulus GmbH
Untitled - bei Regulus GmbH
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
33<br />
Alarm 2<br />
Reset<br />
Type of Reset for contact<br />
of alarm 2<br />
(Automatic Reset)<br />
Default<br />
(Manual Reset)<br />
34<br />
35<br />
36<br />
37<br />
38<br />
39<br />
Alarm 2 State<br />
Error<br />
Alarm 2 Led<br />
Alarm 2<br />
Hysteresis<br />
Alarm 2 Delay<br />
Alarm 2<br />
Setpoint<br />
Protection<br />
Alarm 3<br />
State of contact for alarm<br />
2 output in case of error<br />
State of OUT2 led<br />
corresponding to relative<br />
contact<br />
Alarm 2 hysteresis<br />
Alarm 2 delay<br />
Alarm 2 set protection.<br />
Does not allow operator<br />
to change value of<br />
setpoint<br />
Alarm 3 selection.<br />
Alarm intervention is<br />
associated with AL3<br />
(Manual Reset Stored)<br />
Default<br />
Default<br />
-999…+999 digit ∗<br />
(tenths of degree if temperature).<br />
Default: 0.<br />
-180…+180 Seconds<br />
Negative: delay in alarm output<br />
phase.<br />
Positive: delay in alarm entry phase.<br />
Default: 0.<br />
Default<br />
(Disabled) Default<br />
(Absolute Alarm)<br />
(Band Alarm)<br />
(High Deviation Alarm)<br />
(Low Deviation Alarm)<br />
(Absolute Command setpoint Alarm)<br />
(Start Alarm)<br />
(Cooling)<br />
(Loop Break Alarm)<br />
∗ The display of the decimal point depends on the setting of parameter<br />
and parameter .<br />
36
Change language