Untitled - bei Regulus GmbH

13 Table of Anomaly Signals
In case of malfunctioning of the system, the controller switches off the
regulation output and displays the type of anomaly.
For example the controller will signal the breakage of any connected
thermocouple by displaying
notifications, see the table below.
# Cause What to do
E-01 Error in E ² PROM cell
programming
E-02 Cold junction sensor fault or room
temperature outside of allowed
limits.
E-04 Incorrect configuration data.
Possible loss of calibration values.
E-05 Thermocouple open or
temperature outside of limits.
(flashing) on display. For other
Call Assistance
Call Assistance
Check if the configuration parameters
are correct.
Check the connection with the
sensors and their integrity.
48