AERODESIN 2000 E 02.03.2010.2010 - lysoform

More documents

Recommendations

Info

* · · · · · · · · · · · · · · · · . · · Safety data sheet according to 1907/2006/EG Page: 2/6 Printed on: 2 nd March 2010 Version 3 Revised on: 2 nd March 2010 Trade name: AERODESIN 2000 4. First aid measures General information: Immediately remove all clothing that has been soiled with the product. After inhalation: Plenty of fresh air, if unwell seek medical advice. Nach Hautkontakt: Generally the product does not irritate the skin After eye contact: Rinse out with plenty of running water with the eyelid held wide open for several minutes. Seek medical advice immediately. After swallowing: Drink plenty of water and get some fresh air. Seek medical advice immediately. 5. Fire-fighting measures Suitable extinguishing media: CO2, extinguishing powder or water jet. Fight larger fires with water jets or alcohol-resistant foam. Protective equipment: No special measures required. 6. Procedure in case of accidental release Personal safety precautions: Wear protective equipment. Keep unprotected people away. Measures for environmental protection: Dilute with plenty of water. Do not allow to enter the sewer system/surface waters/groundwater. Cleaning/Collecting procedure: Absorb using liquid-binding material (sand, kieselguhr, acid binder, universal binder, sawdust). Ensure adequate ventilation. 7. Handling and storage Handling: Information about safe handling: Ensure good ventilation/extraction at the workplace. Avoid the formation of aerosol. Information about fire and explosion prevention: Keep away from ignition sources – Do not smoke. Take precautions against electrostatic charging. Storage: Requirements made of storage rooms and containers: No special requirements. Joint storage information: Keep away from foodstuff. Keep away from oxidizing agents. Other information about storage conditions: Store in well-closed packagings in a cool and dry place. At temperatures between 5 – 30 °C Storage class: LGK 3 Flammable Liquids (acc. to VCI) 8. Exposure limitation and control / personal protectionn Additional information about the design of technical systems: No further data, see item 7 Components with critical values that require monitoring at the working place: (Continued from page 1) EN (Continued on page 2) EN (Continued (Continued on on page page 3) 3) EN EN
* . · · · · . . . · · Safety data sheet according to 1907/2006/EG Page: 3/6 Printed on: 2 nd March 2010 Version 3 Revised on: 2 nd March 2010 Trade name: AERODESIN 2000 71-23-8 Propan-1-ol MAK 500 mg/m³, 200 ml/m³ 64-17-5 Ethanol MAK Short-time value: 1920 mg/m³, 1000 ml/m³ Long-term value: 960 mg/m³, 500 ml/m³ 111-30-8 Glutaral MAK Short-time value: 0,42 mg/m³, 0,1 ml/m³ Long-term value: 0,21 mg/m³, 0,05 ml/m³ Additional information : This information is based on the lists that were valid when this data sheet was generated. Personal protective equipment: General precautions and hygienic measures: Immediately remove any soiled, saturated clothing. Wash hand in the breaks and at the end of work. Avoid contact with eyes. Respiration protection: For short-term or low exposure respiration filter device; for intensive or longer exposure use a respiration filter device that operates independent of the circulating air. Hand protection: Protective gloves The material of the gloves must be impermeable and resistant to the product. As compatibility tests are not available no recommendation can be made for the gloves suitable for the product. Choice of gloves under consideration of perforation time, permeation rate and degradation of the materia . Glove material: Butyl rubber Nitrile rubber The selection of the suitable glove not only depends on the material but also on other quality features and varies from manufacturer to manufacturer. As the product is a mixture of several substances, the resistance of the glove materials cannot be calculated in advance and therefore needs to be checked again before use. Penetration time of the glove material: Ask the manufacturer about the exact penetration time and comply with this. Eye protection: Tight-fitting goggles 9 .Physical and chemical properties General information Form: Liquid Colour: No colour Smell: Alcohol-like Change of state Melting point/melting range: Not determined Boiling point/boiling range: Not determined (Continued from page 2) EN (Continued on page 4) EN
Page 1: * * · · · · · Safety data shee
Page 5 and 6: · · · · · · · · · · · ·

AERODESIN 2000 E 02.03.2010.2010 - lysoform

Create successful ePaper yourself

Delete template?

Save as template?