BLANISOL-PUR E 16.11.2009.2009 - lysoform

*
*
*
Safety data sheet
according to 1907/2006/EG
Page: 1/5
Printed on: 16 th November 2009 Version :1 Revised on: 16 th November 2009
1. Product and company identification
Information on the product
Trade name: BLANISOL-PUR
Application: Concentrate for the cleaning of medical devices
Manufacturer Lysoform Dr. Hans Rosemann GmbH
Kaiser-Wilhelm-Straße 133
D-12247 Berlin
Telephone: +49 (0) 30/77992-0 Fax: +49 (0) 30/77992-219
www.lysoform.de
Department providing
information
Contact email:
Emergency information
Germany
Toxic emergency number Munich
Toxicological department,
Klinikum rechts der Isar
Ismaninger Str. 22, 81675 München
Telephone: +49 (0) 89/19240
Fax: +49 (0) 89/4140-2467
2. Hazard identification
·
Scientific-technical department
Telephone: +49 (0) 30/77992-285
kontakt@lysoform.de
Special indications of danger for humans and the environment:
The product must be labelled on the basis of the calculation procedure of the "General
classification guideline for preparations of the EU" in the latest valid version.
R 41 Risk of serious damage to eyes.
3. Composition/details about the components
·
·
·
·
·
Xi Irritant
Switzerland
Swiss toxic information centre
Freiestrasse 16
8030 Zürich
Telephone: 0041 44 2515151
Fax: 0041 44 2528833
Chemical characterisation
Description: Solution of surfactants in water
Hazardous ingredients:
CAS: 69011-36-5 Isotridecanol, ethoxylatedt < 30%
Xn, Xi; R 22-41
CAS: 68424-85-17 Alkydimethybenzylammonium chloride 1%
EINECS 270-325-2 Xn, C, ;R 22-34-50
Regulation (EC) No. 648/2004 on detergents / information on the ingredients
Anionic surfactants 5-15%
Additional information: Please refer to Chapter 16 for the texts of the listed danger indications.
(Continued on page 2)
EN

*
*
*
·
·
·
·
·
·
·
·
Safety data sheet
according to 1907/2006/EG
Page: 2/5
Printed on: 16 th November 2009 Version :1 Revised on: 16 th November 2009
Trade name: BLANISOL-PUR
4. First aid measures
·
·
·
·
·
General information: Immediately remove all clothing that has been soiled with the product.
After inhalation: Plenty of fresh air, if unwell seek medical advice.
After skin contact: Wash immediately with water
After eye contact:
Rinse out with plenty of running water with the eyelid held wide open for several minutes.
Seek medical advice immediately.
After swallowing: Rinse mouth and drink plenty of water. Seek medical advice.
5. Fire-fighting measures
·
·
Suitable extinguishing media:
CO2, extinguishing powder or water jet. Fight larger fires with water jets or alcohol-resistant
foam.
Protective equipment: No special measures required.
Cool down endangered containers by spraying with water.
6. Procedure in case of accidental release
·
·
·
Personal safety precautions:
Not required.
Measures for environmental protection:
Dilute with plenty of water.
Do not allow to enter the sewer system/surface waters/groundwater.
Cleaning/Collecting procedure:
Absorb using liquid-binding material (sand, kieselguhr, acid binder, universal binder, sawdust).
Ensure adequate ventilation.
7. Handling and storage
Handling:
Information about safe handling:
Ensure good ventilation/extraction at the workplace.
Avoid the formation of aerosol.
Information about fire and explosion prevention:
No special measures required.
Storage:
Requirements made of storage rooms and containers: Store in original container only.
Joint storage information:
Not required.
Other information about storage conditions:
Store in well-closed containers.
Storage class: LGK 12 (acc. to VCI)
8. Exposure limitation and control / personal protectionn
·
·
Additional information about the design of technical systems: No further data, see item 7
Components with critical values that require monitoring at workplace:
(Continued from page 1)
EN
(Continued on page 2)
EN
(Continued
(Continued
on
on
page
page
3)
3)
EN
EN

Safety data sheet
according to 1907/2006/EG
Page: 3/5
Printed on: 16 th November 2009 Version :1 Revised on: 16 th November 2009
Trade name: BLANISOL-PUR
·
CAS-Nr. Name of substance Type Value Amount
7664-38-2 phosphoric acid 8 hours 1 mg/m³
Eye protection:
Tight-fitting goggles
9. Physical and chemical properties
General information
·
Form: Liquid
Colour: yellowish
Smell: slightly scented
Change of state
Melting point/melting range: Not determined
Boiling point/boiling range: Not determined
Flash point: > 70,0 °C
Self-ignition: The product is not self-igniting. (continued on page 4)
(Continued from page 2)
EN
· Additional information : This information is based on the lists that were valid when this data sheet was
generated.
·
·
Personal protective equipment:
General precautions and hygienic measures:
Keep away from foodstuff, beverages, animal feed.
Immediately remove any soiled, saturated clothing.
Wash hand before break and at the end of work.
Avoid contact with eyes.
· Avoid contact with eyes and skin.
Respiration protection:
For short-term or low exposure respiration filter device; for intensive or longer exposure
· use a respiration filter device that operates independent of the circulating air.
Hand protection:
The material of the gloves must be impermeable and resistant to the product.
As compatibility tests are not available no recommendation can be made for the gloves suitable for the
product.
· Choice of gloves under consideration of perforation time, permeation rate and degradation of the material .
Glove material:
Butyl rubber
Nitrile rubber
Recommended material thickness: 0,5 mm
The selection of the suitable glove not only depends on the material but also on other
quality features and varies from manufacturer to manufacturer. As the product is a mixture of
several substances, the resistance of the glove materials cannot be calculated in advance and therefore
· needs to be checked again before use.
Penetration time of the glove material:
The penetration time for the mixture of chemicals listed below must be at least 480 minutes (permeation acc.
to EN 374 Part 3: Level 6).
· Ask the glove manufacturer about the exact penetration time and comply with this.

*
*
Safety data sheet
according to 1907/2006/EG
Page: 4/5
Printed on: 16 th November 2009 Version :1 Revised on: 16 th November 2009
·
.
Trade name: BLANISOL-PUR
Risk of explosion: The product is not explosive
Vapour pressure at 20 °C: Not determined
Density at 20 °C: approx. 1,00 g/cm 3
Solubility in/ mixability with
water: Completely mixable.
pH-value (50 g/l) at 20 °C: approx. 7
Viscosity:
Dynamic at 20°C: Not determined
Contents of solvent:
Organic solvents: 0,0 %
Water: approx. 80 %
10. Stability and reactivity
·
·
·
·
·
·
·
·
Thermal decomposition / conditions to be avoided:
No decomposition if used properly.
Dangerous reactions: No dangerous reactions known.
Dangerous products of decomposition: No dangerous decomposition products known.
11. Toxicological information
·
Acute toxicity:
Primary irritation:
on skin: Irritating.
in eyes: Irritating
Sensitisation: No sensitisation known.
Further toxicological information:
Due to the calculation procedure of the "General Classification guideline for preparations of the EU" in the
latest valid version, the product has the following risks:
Irritating
12. Ecological information
·
Information about elimination (persistence and degradability):
Biodegradable
The surfactant in this preparation satisfies the conditions of the biological degradability as defined
in the regulations (EU) No. 648/2004 resp. CH in the ChemRRV on detergents.
General information:
Water pollutant class (German legislation) 1 (self-classification): Slightly water polluting
Do not allow to enter the groundwater, waters or the sewer system, if undiluted or in large
quantities.
·
·
(Continued from page 3)
(Continued on page 4)
EN
EN
(Continued on page 5)
EN

*
*
Safety data sheet
according to 1907/2006/EG
Page: 5/5
Printed on: 16 th November 2009 Version :1 Revised on: 16 th November 2009
Trade name: BLANISOL-PUR
13. Disposal consideration
· Product:
Recommendation:
May not be disposed of together with the household waste. Do not allow to enter the sewer system.
·
·
·
·
European Waste Code
07 04 01 washing liquids and mother lye
Soiled packaging:
Recommendation: Dispose of in accordance with the official regulations.
Recommended cleaning agent: Water, possibly with detergent additives.
14. Transport information
·
·
·
Land transport ADR/RID and GGVS/GGVE (cross-border/Germany):
ADR/RID-GGVS/E class: -
Sea transport IMDG/GGVSee: -
IMDG/GGVSea class: -
Air transport ICAO-TI and IATA-DGR: -
ICAO/IATA-class: -
15. Regulatory information
.
.
.
.
·
·
Label according to the EEC Directives:
The product has been classified and identified according to the EC Directives/Hazardous Goods Ordinance.
Code letter and danger indication of the product:
Xi Irritant
R-phrases:
41 Risk of serious damage to eyes.
S-phrases:
26 In case of contact with eyes, rinse immediately with plenty of water and seek medical advice.
36/37/39 Wear suitable protective clothing, gloves and eye/face protection.
61 Avoid release to the environment. Refer to special instructions/ Safety data sheets.
National regulations:
Other regulations, restrictions and prohibitions
Water polluant class (German legislation) WGK 1 (self-classification): slightly water polluting
Medical device Cl. I CE acc. to German MPG
16. Other information
The information contained herein is based on the present state of our knowledge. It does not represent a
·
·
·
·
guarantee of the properties of the product or form the basis for a legal position.
Relevant R-phrases
22 Harmful if swallowed.
34 Causes burns.
41 Risk of serious damage to eyes.
50 Very toxic to aquatic organisms.
Area issuing the data sheet: Department Product Safety
Contact partner: Dr. G. Cielusek
* Data changed compared to previous version
(Continued from page 4)
EN
EN