BLANISOL-PUR E 16.11.2009.2009 - lysoform

More documents

Recommendations

Info

* * * · · · · · · · · Safety data sheet according to 1907/2006/EG Page: 2/5 Printed on: 16 th November 2009 Version :1 Revised on: 16 th November 2009 Trade name: BLANISOL-PUR 4. First aid measures · · · · · General information: Immediately remove all clothing that has been soiled with the product. After inhalation: Plenty of fresh air, if unwell seek medical advice. After skin contact: Wash immediately with water After eye contact: Rinse out with plenty of running water with the eyelid held wide open for several minutes. Seek medical advice immediately. After swallowing: Rinse mouth and drink plenty of water. Seek medical advice. 5. Fire-fighting measures · · Suitable extinguishing media: CO2, extinguishing powder or water jet. Fight larger fires with water jets or alcohol-resistant foam. Protective equipment: No special measures required. Cool down endangered containers by spraying with water. 6. Procedure in case of accidental release · · · Personal safety precautions: Not required. Measures for environmental protection: Dilute with plenty of water. Do not allow to enter the sewer system/surface waters/groundwater. Cleaning/Collecting procedure: Absorb using liquid-binding material (sand, kieselguhr, acid binder, universal binder, sawdust). Ensure adequate ventilation. 7. Handling and storage Handling: Information about safe handling: Ensure good ventilation/extraction at the workplace. Avoid the formation of aerosol. Information about fire and explosion prevention: No special measures required. Storage: Requirements made of storage rooms and containers: Store in original container only. Joint storage information: Not required. Other information about storage conditions: Store in well-closed containers. Storage class: LGK 12 (acc. to VCI) 8. Exposure limitation and control / personal protectionn · · Additional information about the design of technical systems: No further data, see item 7 Components with critical values that require monitoring at workplace: (Continued from page 1) EN (Continued on page 2) EN (Continued (Continued on on page page 3) 3) EN EN
Safety data sheet according to 1907/2006/EG Page: 3/5 Printed on: 16 th November 2009 Version :1 Revised on: 16 th November 2009 Trade name: BLANISOL-PUR · CAS-Nr. Name of substance Type Value Amount 7664-38-2 phosphoric acid 8 hours 1 mg/m³ Eye protection: Tight-fitting goggles 9. Physical and chemical properties General information · Form: Liquid Colour: yellowish Smell: slightly scented Change of state Melting point/melting range: Not determined Boiling point/boiling range: Not determined Flash point: > 70,0 °C Self-ignition: The product is not self-igniting. (continued on page 4) (Continued from page 2) EN · Additional information : This information is based on the lists that were valid when this data sheet was generated. · · Personal protective equipment: General precautions and hygienic measures: Keep away from foodstuff, beverages, animal feed. Immediately remove any soiled, saturated clothing. Wash hand before break and at the end of work. Avoid contact with eyes. · Avoid contact with eyes and skin. Respiration protection: For short-term or low exposure respiration filter device; for intensive or longer exposure · use a respiration filter device that operates independent of the circulating air. Hand protection: The material of the gloves must be impermeable and resistant to the product. As compatibility tests are not available no recommendation can be made for the gloves suitable for the product. · Choice of gloves under consideration of perforation time, permeation rate and degradation of the material . Glove material: Butyl rubber Nitrile rubber Recommended material thickness: 0,5 mm The selection of the suitable glove not only depends on the material but also on other quality features and varies from manufacturer to manufacturer. As the product is a mixture of several substances, the resistance of the glove materials cannot be calculated in advance and therefore · needs to be checked again before use. Penetration time of the glove material: The penetration time for the mixture of chemicals listed below must be at least 480 minutes (permeation acc. to EN 374 Part 3: Level 6). · Ask the glove manufacturer about the exact penetration time and comply with this.
Page 1: * * * Safety data sheet according t
Page 5: * * Safety data sheet according to

BLANISOL-PUR E 16.11.2009.2009 - lysoform

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?