SECTION 02522 BRICK UNIT PA VrNG PART 1 - GENERAL ...

B. Manufacturer's product data:
J. Complete materials list of all materials proposed to be furnished and
installed under this section.
2. Specifications and other data required that demonstrate compliance with
the specified requirements.
3. Submit sieve analyses for grading of bedding and joint sand.
Samples:
I. Submit two (2) full size samples of brick unit pavers proposed for usc.
1.03 QUALITY A~SURANCE
A. Qualil~cations of manufacturer:
I .
Products used in the work 0 f this section sha II be produced by
manufacturers regularly engaged in the manufacture of similar items and
with a history of successful production acceptable to the ENGINEER.
B. Quajifications ofwol'kmcn:
I. Provide at least one person who shall be prcscnt at aU times during
execution of the work ofthis section, who shall be thoroughly familiar
with the specified requirements and the materials and methods needed flir
their execution, and who shall direct all work: performed tmder this
section.
2. Provide adequate numbers ofworkmcn skilled in the necessary eratls and
properly informed ofthe method and materials to be used.
3. In acceptance or rejection o1't11c work of this section, the ENGINEER. \vitl
make no allowance f(x lack of skill on the part of workmen.
C. Basis of acceptance:
I. The manuf~lctUl'Cr's installation instructions will provide the basis for
acceptance or rejection ofthe work performed under this section.
ivlOORESTOWN "('\Vf'.
Contract No. 20 J 2-7
;\-()730.... 0044-000/S20S6
September 10,2012
Brick Unit P