Side-by-side comparison of ANSI/ISEA Z87.1-2003 and ... - US Safety

More documents

Recommendations

Info

ANSI/ISEA Z87.1-2003/2010 Comparison – page 8 Assessments for Hazard-Based Protectors IMPACT RATED (referred to as high-impact in 2003 standard) Criteria ANSI/ISEA Z87.1-2003 ANSI/ISEA Z87.1-2010 Notes/Rationale Frames and Shells Section 7.2 Section 6.1.2 2010 version requires that plano spectacles are to be tested as complete devices and allows prescription spectacles to be tested with a representative test lens Testing extended to frames and shells encompass testing of welding helmets. Lateral (side coverage) None. Section 6.1.3 (criteria) Section 9.10.1 (test method) 2010 standard now requires lateral coverage for impact rated protectors. Inclusion is consistent with other international product standards. Assessment criteria and test method written to accommodate spectacles designed to be tested on the smaller headform.
ANSI/ISEA Z87.1-2003/2010 Comparison – page 9 Criteria ANSI/ISEA Z87.1-2003 ANSI/ISEA Z87.1-2010 Notes/Rationale High Mass High Velocity Criteria for individual protectors. See: Section 7.2.1 Section 7.4.2.1.1 Section 8.2.1.1 Section 8.3.1.1 Section 9.2.1.1 Section 9.3.1.1 Section 10.2.1.1 Section 10.3.1.1 Section 14.1 (test method) Criteria for individual protectors. See: Section 7.2.2 Section 7.4.2.1.2 Section 7.5.2.1 Section 8.2.1.2 Section 8.3.1.2 Section 9.2.1.2 Section 9.3.1.2 Section 10.2.1.2 Section 10.3.1.2 Section 14.2 (test method) Section 6.2.2 (criteria) Section 9.11 (test method) Section 6.2.3 (criteria) Section 9.12 (test method) Table 5 No change in pass/fail criteria. Test method language clarifies designated test height (50 in.) and changed the spherical radius of the missile from 1mm (2003) to 3.175mm (2010) revision to provide a more “blunt” impact. Includes language to accommodate prescription lens carriers. No change in pass/fail criteria. Velocities have been consolidated into a single table. Assessment criteria and test method written to accommodate spectacles designed to be tested on the smaller headform. Testing includes fewer impact sites, in 30° increments and defines the area of where the impact must occur at each test point. Includes language to accommodate prescription lens carriers.
Page 1 and 2: Side-by-side comparison of ANSI/ISE
Page 3 and 4: ANSI/ISEA Z87.1-2003/2010 Compariso
Page 7: ANSI/ISEA Z87.1-2003/2010 Compariso
Page 15: ANSI/ISEA Z87.1-2003/2010 Compariso

Side-by-side comparison of ANSI/ISEA Z87.1-2003 and ... - US Safety

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?