PAS 400 Installation Kits

More documents

Recommendations

Info

4.2 Assembly Remove the battery cover hinges from both receivers (push out with a small screwdriver) 7 9 6 5b Install the DC adapters into the battery compartments. Attach a rubber bumper to each DC adapter, as shown Page 24 Attach a felt strip to each angled support bracket, as shown
7 5a Clip each receiver to an angled support bracket, as shown. Plug the mini-plugs into the output jacks 8 Fasten each BodyPack receiver to the front panel with two M3 x 8 screws Page 25
Page 1 and 2: freePORT PAS 400 TM Installation Gu
Page 3 and 4: 1. PAS 400 EM for 1 Sennheiser evol
Page 5 and 6: 5b 3 5a 3 Plug the DC power connect
Page 7 and 8: 1.3 Installation Disconnect the rib
Page 9 and 10: 2. PAS 400 BP for 1 Sennheiser evol
Page 11 and 12: 7 5a Clip the receiver to the angle
Page 13 and 14: 4 8 Fasten the connector module to
Page 15 and 16: Install the receiver installation k
Page 17 and 18: 3. PAS 400 DD for 1 K + H PDD 63 Di
Page 19 and 20: Fasten the connector module to the
Page 21 and 22: Install the digital delay installat
Page 23: 4. PAS 400 BP2 for 2 Sennheiser evo
Page 27 and 28: 4 8 Fasten the connector module to
Page 29 and 30: Install the receiver installation k
Page 31: 5. PAS 400 BP2 for 1 Sennheiser evo

PAS 400 Installation Kits

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?