DIRECT VENT GAS WATER HEATER - Bradford White
DIRECT VENT GAS WATER HEATER - Bradford White
DIRECT VENT GAS WATER HEATER - Bradford White
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
THERMOSTAT ADJUSTMENT - <strong>White</strong> Rodgers gas control.<br />
160°F Control 180°F Control<br />
Figure 5<br />
The thermostat dial is set to its lowest temperature setting when shipped from the factory.<br />
Remember that lower temperature settings are more energy efficient. Adjust the<br />
temperature by turning the thermostat dial. It is suggested that the starting point setting not be<br />
greater than the ” “ or “ “mark on the thermostat dial (approximately 120°F [48.9°C]) as<br />
indicated above. Rotate the thermostat dial clockwise to decrease the temperature<br />
setting. Rotate the thermostat dial counter-clockwise to increase the temperature<br />
setting. Adjust the dial until the minimum acceptable temperature is achieved (See figure 5<br />
above for approximate temperature settings).<br />
Robertshaw gas control.<br />
160°F Control 180°F Control<br />
Figure 6<br />
The thermostat dial is set to its lowest temperature setting when shipped from the factory.<br />
Remember that lower temperature settings are more energy efficient. Adjust the<br />
temperature by turning the thermostat dial. It is suggested that the starting point setting not be<br />
greater than the “ ” mark on the thermostat dial (approximately 120°F [48.9°C]) as indicated<br />
above. Rotate the thermostat dial counter-clockwise to decrease the temperature<br />
setting. Rotate the thermostat dial clockwise to increase the temperature setting.<br />
Adjust the dial until the minimum acceptable temperature is achieved (See figure 6 above for<br />
approximate temperature settings).<br />
21