Infortrend firmware functionality, configuration thru ... - ENEA AFS Cell

xviii
Chapter 10 Enclosure Management Page Number
10.1 Enclosure Monitoring 10-1
SAF-TE and SES Enclosure Monitoring (Periodic SAF-
TE and SES Device Check Time)
10-1
Enclosure Device Status 10-2
Event Triggered Operations 10-3
Dynamic Caching Mode Switch 10-5
Controller Auto-Shutdown 10-5
Controller Self-Monitoring 10-5
Changing Monitoring Thresholds 10-6
10.2 UPS Support 10-7
Chapter 11 Data Integrity Page Number
11.1
11.2
Protections against Hardware Faults 11-2
Event Triggered Operations 11-2
Auto-Shutdown on Elevated Temperature 11-3
Maintenance 11-10
Detection of Drive Hot Swap Followed by Auto Rebuild 11-10
Periodic Drive Check Time 11-11
Idle Drive Failure Detection 11-11
Auto-Assign Global Spare Drive 11-12
Task Scheduler 11-13
Task Scheduler Options 11-14
Regenerating Logical Drive Parity 11-17
Disk Array Parameters 11-18
Rebuild Priority 11-19
Verification on Writes 11-20
Chapter 13 Redundant Controller Configuration
13.3 Configuration 13-20
13.3.1 Via Front Panel Keypad 13-20
Redundant Configuration Using Automatic Setting 13-21
Redundant Configuration Using Manual Setting 13-22
Starting the Redundant Controllers 13-23
Creating Primary and Secondary IDs 13-24
Assigning a Logical Drive/Logical Volume to the
Secondary Controller
13-25
Mapping a Logical Drive/Logical Volume to the Host
LUNs
13-26
Front Panel View of Controller Failure 13-26
When and How is the Failed Controller Replaced 13-26
13.3.2 Via Terminal Emulation 13-27
Redundant Configuration Using Automatic Setting 13-27
Redundant Configuration Using Manual Setting 13-28
Creating Primary and Secondary IDs 13-30
Assigning a Logical Drive/Logical Volume to the
Secondary Controller
13-30
Mapping a Logical Drive/Logical Volume to the Host
LUNs
13-31
Page Number:
LCD/Terminal