HDLCR - Niles Audio
HDLCR - Niles Audio
HDLCR - Niles Audio
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
CONNECTING AND INSTALLING THE SPEAKER<br />
1. At each speaker, separate the speaker wire so that at least 2 inches of each conductor<br />
are free. Strip away 1/4 inch of insulation from each speaker wire.<br />
2. On each set of speaker connectors, press down the spring-loaded lever, insert the appropriate<br />
conductor, and then release the lever, as shown in Figure 15. Gently tug on<br />
the speaker wire to make sure it is held in place. If not, repeat this procedure until it is.<br />
NOTE: OBSERVE CORRECT POLARITY: POSITIVE (+) GOES INTO THE RED TERMINAL AND<br />
NEGATIVE (–) GOES INTO THE BLACK TERMINAL.<br />
3. Connect the other end of each speaker wire to the receiver (or amplifier) in the same<br />
way. If you are unsure of wire polarity, see the next section, Checking Speaker Phase<br />
on page 20.<br />
NOTE: OBSERVE CORRECT POLARITY: POSITIVE (+) GOES INTO THE RED TERMINAL AND<br />
NEGATIVE (–) GOES INTO THE BLACK TERMINAL.<br />
4. Install the speaker baffle into its frame by inserting the tabs at the base into the corresponding<br />
holes in the frame and pushing the speaker forward until the snaps engage,<br />
as shown in Figure 16.<br />
NILES AUDIO CORPORATION – 1-800-BUY-HIFI<br />
CTR L/R<br />
Figure 16. Installing the speaker baffle into its frame.<br />
Figure 15. Connecting a speaker<br />
wire to the <strong>HDLCR</strong> terminals.<br />
(CONTINUED ON NEXT PAGE)<br />
19