your Interactive PDF w/bookmarks - Tyson Tool Company Limited
your Interactive PDF w/bookmarks - Tyson Tool Company Limited
your Interactive PDF w/bookmarks - Tyson Tool Company Limited
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
MODULHARD’ANDREA<br />
Testarossa<br />
TRC<br />
0.0002"<br />
Radial Adjustment on Dial<br />
0.00005"<br />
Radial Adjustment on Vernier<br />
TRC<br />
Ø .10 - 7.87<br />
TRC-14<br />
Ø .57 - .71<br />
TRC-16<br />
Ø .71 - .94<br />
TRC-20<br />
Ø .87 - 1.18<br />
TRC-25<br />
Ø 1.10 - 1.57<br />
TRC-32<br />
Ø 1.38 - 2.09<br />
TRC-40<br />
Ø 1.89 - 2.60<br />
TRC-50<br />
Ø .10 - 4.33<br />
TRC-63<br />
Ø 2.83 - 4.92<br />
TRC-80<br />
Ø 3.46 - 7.87<br />
Important note<br />
- Take care that the tools and tool holders are locked on the slide. The only maneuvering and adjustment<br />
screws to be used are those listed in the components section.<br />
- The screws not listed in the components section should not be touched in order not to compromise the<br />
correct operation of boring bars and heads.<br />
- Bit holders and boring bars should be assembled with the insert facing the same direction as the clamp<br />
screw (5) (see photo).<br />
- Remember to loosen the screw (5) before adjusting the dial (4). Lock the screw (5) at the end of the<br />
adjustment.<br />
The micrometric adjustment of POSITIVE is carried out by turning the dial (4) counter-clockwise.<br />
The use of coolant on the TRC heads should be 40 BAR max.<br />
49
Change language