INSTRUCTION HANDBOOK - Utax

Copy Functions
Proof Copy
Make a test copy of a single set to verify settings before printing the remaining sets. If a problem is
found, avoid wasting paper canceling the remaining copy job.
Follow the steps below to do a Proof copy job.
1 Press [Function] and then press [ Down].
2 Press [Proof Copy] ([Test Copy]).
3 Press [On].
Ready to Proof Copy. ( )
Paper Size
Full-Color 11×8
100%
Proof Copy
Shortcut
Back
Off
Proof copy outputs one set for proo
On
4 Place the original and press the Start key. The proof copy begins.
5 After printing a single test copy, a
confirmation screen will be displayed,
and the copier will remain in standby
mode until the job is approved or
cancelled. Check the proof copy.
If it is acceptable, press the Start key.
The remaining sets will be printed.
To change the copy quantity, press
[Change Preset] and change the copy
count.
Orig. Page
11×8½"
1 sided
Top Edge
If there is a problem with the copy, press [Cancel] to redo the copy settings.
Job
Check proof copy.
To stop and retry, press "Cancel" key.
To continue to print, press "Start" key.
APS
Count/Set
11×8½"
Color, 1 side
Plain
Output
Top tray
Change
Preset
1-35