J-Flash ARM User Guide - SEGGER Microcontroller

16 CHAPTER 2 Licensing
2.1 Introduction
J-Flash may be installed on as many host machines as you want. Without a license
key you can still use J-Flash to open project files, read from connected devices, blank
check target memory, verify data files and so on. However to actually program
devices via J-Flash and J-link you are required to obtain a license key from us. A J-
Flash license is bound to the serial number of a J-Link. Evaluation licenses which
allow you to unlock the full potential of J-Flash for a limited period of time are available
upon request. If you need an evaluation license key you only have to tell us the
serial number of your J-Link which allows us to send you a proper key. In any case
you need to have a license key for each J-Link you want to work with via J-Flash. The
following sections describe common operations with reference to handling license
keys.
J-Flash ARM (UM08003) © 2004-2012 SEGGER Microcontroller GmbH & Co. KG