SG-8C20 - Paul Lange & Co

More documents

Recommendations

Info

20 16. Remove the clutch unit by turning it counterclockwise and aligning the two teeth to the two grooves, as shown. This completes the disassembly of the INTER-8 coaster hub. Clutch unit (Y-35P 98060)
Assembly of the INTER-8 coaster hub 1. With the hub axle unit mounted in a vice, align the two teeth on the clutch unit with the two notches in the hub axle unit. Turn the clutch unit clockwise until it is in its final position as shown. Clutch unit (Y-35P 98060) 2. Install the return spring with the largest coil downward. The spring should sit in the groove on the clutch unit, shown as a blue line in the picture. Be careful not to install the return spring A upside down. 3. Assemble the driver unit by aligning the more shallow notch on the driver unit with the wider tooth on the clutch unit. Rotate the driver counterclockwise to hold the compressed spring in position. Clutch unit (Y-34R 98050) NOTE: During the assembly procedures coat all seals, gears and pawl assemblies with a thin coat of Nexus specific grease. Where indicated by blue grease icon, apply grease liberally. (Y-041020800) Return spring A (Y-34R 21000) Set drive unit while turn it counterclockwise. NOTE: Assemble the driver unit while pushing pawls B as shown in the picture. 21
Page 1: GB SHIMANO NEXUS INTER-8 COASTER HU
Page 4 and 5: 4 The new standard in internal gear
Page 6 and 7: 6 General Safety Information - To a
Page 8 and 9: General Safety Information - To avo
Page 10 and 11: 10 General Safety Information WARNI
Page 12 and 13: 12 Troubleshooting Chart SHIMANO NE
Page 14 and 15: 14 Replacement of the internal unit
Page 16 and 17: 16 Disassembly of the internal unit
Page 18 and 19: 18 9. Remove the lock washer. 10. R
Page 22 and 23: 22 4. Install the ball retainer P (
Page 24 and 25: 24 11. Install the ball retainer O
Page 26 and 27: 26 14. Insert the stop ring. NOTE:
Page 28 and 29: 28 Cassette Joint CJ-8S20 for 8 spe
Page 30 and 31: 30 NEXUS non-turn washers NEXUS non
Page 32 and 33: 32 Spare parts list CJ-8S20 1 29 25
Page 34 and 35: 34 Spare parts list SHIMANO NEXUS C
Page 36: BJARNE EGEDESØ A/S Denmark, Icelan

SG-8C20 - Paul Lange & Co

Create successful ePaper yourself

Delete template?

Save as template?