M - tormatic

More documents

Recommendations

Info

+ - + - - + 14c 14d - + - + 14e 11c 14f 14g 14h
16 F< 400N F= 15 17 LIGHT DO UP N PE Receiverboard 12V SE GND PC STOPA IMP ANT N L LIGHT S2 18 Special settings The setting can be altered via Dip switches. S1 S8 1 2 S2 S2 Safety Edge Input I is configurated for a Optical Safety Edge. (factory setting) Input I is configurated for a Electic Saftey Edge with 1K2 resistor. H I c 1 2 S3 1K2 Automatic Closing Mode Press Button to open the door. After the desired hold open time set switch S3 on. In this mode photo cells are required. Early warning phase The early warning phase is set, the light starts 4 seconds before the operator starts up. 18 S4 S6 S6 S7 Protection against drawing in An external photocell safety device to detect a person who is in danger to be drawn in. If the photocell is interrupted whilst the door is closing,or opening thedoor stops immediately. Safety edge If the closing door encounters an obstruction, the operator stops and causes the door reopensto its top end-of-travel position. The opening door encounters an obstruction, the operator stops immediately. 19
Page 1 and 2: Deluxe Installation Guide WN 020692
Page 3 and 4: 2d 3a 40 mm 40 mm 80 mm 80 mm 6 mm
Page 5 and 6: M PE BL UP DOWN yellow/green blue b
Page 7 and 8: I h I H G F E LS 5 LS 5 1 2 3 +V -V
Page 9: 2 sec 12a 12b 13a 13b 13d + - + - 1
Page 13 and 14: GB • Installation Instructions Re
Page 15 and 16: • Trouble-shooting Guide Importan
Page 17: Proof of Inspection and Maintenance

M - tormatic

Create successful ePaper yourself

Delete template?

Save as template?