ER-A220 Operation-Manual GB - Sharp

DISPLAYS
Operator display
Customer display (Pop-up type)
PLU/SUB
DEPT
REPEAT
RCPT
OFF
cashier code
Amount:
Appears in the far-right eight (max.) positions.
Cashier code: Appears in the second position (one digit).
Number of repeats for repetitive registrations:
The number of repeats is displayed, starting at “2” and incremented with each repeat.
When you have registered ten times, the display will show “0.”
Example: (2 → 3 → 4 ..... 9 → 0 → 1 → 2 ... )
Receipt function status:
The indicator “_” appears in the ninth position when the receipt function is put in the OFF
status.
Time:
Appears in the second to sixth positions (using 24-hour format) in the OP X/Z, REG, or
MGR mode. In the REG, or MGR mode, press the Ñ key to display the time.
Machine state symbols
: Appears in the tenth place during programming.
: Appears in the tenth place when an error is detected.
– (Floating): Appears when a minus department or PLU/subdepartment entry is made or when a discount,
refund, or void entry is made.
: Appears in the tenth place when the subtotal is displayed or when the amount tendered is smaller
than the sale amount.
: Appears in the tenth place when the e key is pressed to calculate a subtotal in foreign currency.
: Appears in the tenth place when a transaction is finalized by pressing the É, ' or î key.
: Appears in the tenth place when the change due amount is displayed or when the cash/cheque
declaration is compulsory.
– : May appear in the far-left three positions at the timing of key entry when the electronic journal
memory is full. (Depending on programming.)
: May appear right below the eighth and ninth places at the timing of finalization of a transaction
when the electronic journal memory is nearly full. (Depending on programming.)
Also appears right below the tenth place when power saving mode is effective.
7