HM-4200 manual GB.book - Soco Systems
HM-4200 manual GB.book - Soco Systems
HM-4200 manual GB.book - Soco Systems
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
8. Belt adjustment on drive<br />
8.1 Mounting of drive<br />
D<br />
Holes for mounting of drive<br />
B<br />
C<br />
A<br />
8.2 Tightening of driving belt<br />
Dismount cover plate (A). Tighten the retaining iron completely by means of the two screws (B) which<br />
are then loosened one turn. Draw two lines on the slack belt with a distance of 500 mm (alternatively<br />
1000 mm). Tighten by means of screws (C) while making sure that the shaft of the tension rollers is at<br />
right angle to the cassette profile. Tighten approx. 0.5%, i.e. the distance between the two lines must<br />
increase to 502.5 mm (alternatively 1005 mm).<br />
8.3 Adjustment of driving belt<br />
The drives must operate during belt adjustment. Tighten the retaining iron slightly by means of screws<br />
(B). Adjust the belt for operation at the centre of the tension roller by adjusting one of the screws (C).<br />
Adjust at drive end by turning set screw (D). When the belt is adjusted, tighten screws (B), and mount<br />
the cover plate.<br />
9732850011_<strong>HM</strong>-<strong>4200</strong> <strong>GB</strong>_Version 3_2011.11.17<br />
Tel.: +45 43 52 55 66 Fax: +45 43 52 81 16 info@socosystem.com www.socosystem.com<br />
13