HM-4200 manual GB.book - Soco Systems

5.4 Start/stop/emergency stop
■ The main swith on the machine (7) must be switched to position 1 (ON).
■ Compressed air must be connected and the compressed air cock must be open (9 and 10).
■ The main switch on the glue tank must be switched to ON position. Check that there is glue in the
tank.
■ Check that all necessary carton size settings have been made (see the section “Setting of
formats”).
■ Close the doors in the guarding and check that the emergency stop switch (5) is pulled out.
■ Push the AIR ON button (3). Air is connected to the machine and the white pushbutton with light
(3) lights constantly. If this is not the case see the chapter regarding alarms.
■ Push start (1). The machine now automatically starts a top sealing sequence. The green
pushbutton with light lights constantly. If this is not the case see the chapter on handling of
alarms.
IMPORTANT: The glue tank indicator lamp must light green otherwise it is not possible to start the carton
sealer. If the indicator lamp switches off when the machine is in operation the machine stops and it
cannot be restarted until the indicator lamp lights.
Stop
Push the black button stop/reset (2) briefly to stop the machine when the top sealing sequence has
ended.
Reset
Push the black stop/reset button (2) for 5 seconds to reset the machine until the green start button (1)
flashes 3 times. This function is used when an alarm has occurred (see alarm instructions). All functions
are reset which means that the machine returns to its initial position when air has been supplied to the
machine or when air is supplied to the machine again.
Emergency stop switch
If the emergency stop switch (5) is activated the machine stops and is vented immediately. This also
takes place if a door is opened.
Queue control photocell S10
When the photocell for queue control S10 (see wire diagrams) is activated the top sealing sequence is
completed and the machine waits with the carton in the compression arrangement. When the photocell
is free the carton is led out of compression arrangement and a new carton is led into the compression
arrangement for sealing.
9732850011_HM-4200 GB_Version 3_2011.11.17
Programme operation without cartons
The machine is preprogrammed to operate without glueing for demonstration purposes. It is not required
that the glue tank is connected and it is also not required that the movement speeds are adjusted. The
machine must be stopped.
■ Push the start button (1) and the stop button (2) for 3 seconds until the white AIR ON button (3)
flashes 3 times.
■ Now release the start button (1) and then push start again and the machine carries out the entire
sequence over and over again until the stop button is activated.
Tel.: +45 43 52 55 66 Fax: +45 43 52 81 16 info@socosystem.com www.socosystem.com
9