Volvo Driver Information Display System - Westside Motorcoach

More documents

Recommendations

Info

Driver Information Display (DID) 87 Acknowledging Messages A fault message is acknowledged by pressing the Esc button after which the display returns to the same status that existed before the fault occurred. All messages can be acknowledged. Acknowledged but inactive messages are displayed again when the ignition key is turned to the START position or they can be read in the menu. Information or Warning Messages: Information and warning messages can be acknowledged using the “Esc” button. This warning stays acknowledged until the next time the ignition key is turned to the START position. Exceptions: The message can be displayed again if the fault is corrected and then becomes active again. Example: If the transmission fluid temperature is too high, a message will be activated automatically. The operator acknowledges this message using the Esc button. If the temperature then drops to a normal level temporarily and then increases again to an excessive level, the warning will activate again. Stop Message: The buzzer and a STOP message can be acknowledged using the Esc button, but may become active again 10 seconds after the last acknowledgment. The STOP symbol will be illuminated the whole time. Examples of Fault Symbols and Text Factory–Installed Equipment When Stationary The stop, warning, or info symbol comes on and the information message is shown on the display (for more information on the fault, see “1. Fault Diagnostics” on page 55). A warning tone will be heard if the engine is running when a stop message is activated. The message contains information about the location of the fault where the fault has occurred:
88 Driver Information Display (DID) Non-Factory-Installed Equipment If a coach builder or customer has retrofitted equipment that is connected to the data link, the following symbols may be displayed: MID (Message IDentifier) = control unit
Page 2 and 3:
Table of Contents i Foreword . . .
Page 4 and 5:
Foreword 1 FOREWORD This manual con
Page 6 and 7:
Driver Information Display (DID) 3
Page 8 and 9:
Page 10 and 11:
Page 12 and 13:
Page 14 and 15:
Page 16 and 17:
Setup 1. Language Driver Informatio
Page 18 and 19:
Page 20 and 21:
Page 22 and 23:
Page 24 and 25:
Page 26 and 27:
Page 28 and 29:
5. Idle Percent Driver Information
Page 30 and 31:
Time/Distance Driver Information Di
Page 32 and 33:
Page 34 and 35:
Page 36 and 37:
Page 38 and 39:
Volvo Link Driver Information Displ
Page 40 and 41: 2. Favorite Display Driver Informat
Page 42 and 43: Driver Information Display (DID) 39
Page 48 and 49: 2. Units Distance Fuel Consumptio
Page 56 and 57: 2. Fleet ID Driver Information Disp
Page 64 and 65: 2. Sweet Spot Data Driver Informati
Page 94 and 95: Index 91 A Acknowledging Messages .
Page 96 and 97: Index 93 R Reset (Driving Mode DID)
show all

Volvo Driver Information Display System - Westside Motorcoach

Create successful ePaper yourself

Delete template?

Save as template?