ST-360 POH - Tdmk.pmd - OU Aviation

More documents

Recommendations

Info

2.1 Pre-Flight Test S–TEC Prior to takeoff and with engine running, perform the actions shown in Table 2-1. For each action, verify the corresponding response where applicable. Table 2-1. Pre-Flight Test (continued on page 2-4) ACTION 1. Set Battery Master Switch to ON position. RESPONSE ------ 2. Set Avionics Master Switch to ON position. ------ 3. Set Transponder Master Switch to ON position. ------ 4. Set Encoding Altimeter / Blind Encoder Master Switch to ON position. ------ 5. Set Autopilot Master Switch to ON position. ------ 6. Complete Autopilot Pre-Flight Procedures contained in respective <strong>POH</strong>. ------ 7. Set ALT Alerter Master Switch to ON position. A two-tone audible alert sounds once. All left numeric segments, all right polarity / numeric segments, and all annunciations (ENT, ALT, SEL, ALR, DH, VS, BARO) appear on Selector / Alerter display for 5 seconds, as shown in Fig. 2-1. Thereafter, only ENT annunciation and left numeral 29.9 (barometric pressure in inches mercury) appear, along with a flashing BARO annunciation, as shown in Fig. 2-2. 2nd Ed. Jan 15, 08 2-3
S–TEC Fig. 2-1. Selector / Alerter Display, All Segments and Annunciations Appear Fig. 2-2. Selector / Alerter Display, Enter Barometric Correction 2-4 2nd Ed. Jan 15, 08
Page 1 and 2: S-TEC Pilot’s Operating Handbook
Page 3 and 4: Sec. Table of Contents S-TEC Pg. 1
Page 5 and 6: S-TEC SECTION 1 OVERVIEW 2nd Ed. Ja
Page 7 and 8: S-TEC The Encoding Altimeter / Blin
Page 9: S-TEC SECTION 2 PRE-FLIGHT PROCEDUR
Page 13 and 14: S-TEC Table 2-1. Pre-Flight Test (c
Page 15 and 16: 3.1 Selector / Alerter Operation S-
Page 17 and 18: 3.1.4 Vertical Speed (VS) Select S-
Page 19 and 20: 3.1.5 Decision Height (DH) Select S
Page 21 and 22: 3.2 Autopilot Operation S-TEC Progr
Page 23 and 24: 4.1 Ranges S-TEC Altitude (ALT) Sel
Page 25 and 26: Term A/C AFM AFMS ALR ALT BAR BARO

ST-360 POH - Tdmk.pmd - OU Aviation

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?