Compact Manual 0303 - Solar Energy Australia

Solar Energy Australia
Compact
To Program Float Voltage
AC IN
AC OUT
CHARGER
SOLAR CHARGE
Program
Contact Active
Contact Manual
PROGRAM
(Aux Contact)
27.4v
27.2v
27.0v
26.8v
26.6v
INVERTER
SELECT
(Reset Alarm)
Set Equalisation
Voltage (Over Temp)
Set Absorption
Voltage (Overload)
Set Float Voltage (Batt High/Low)
Set Low Voltage (OFF)
CHANGE STATUS
(ON/OFF)
Absorption
Time
* To enter the programming mode hold down, the “Program” button and the “Change status” as shown
above, for minimum 2 seconds simultaneously.
* Press the “Select” button until the Red LED next to “Set Float Voltage” is lit, then use the “Change
Status” button to select the value you require as indicated on the 5 centre LED’s.
To Program Equalisation Voltage
AC IN
AC OUT
CHARGER
SOLAR CHARGE
Program
Contact Active
Contact Manual
PROGRAM
(Aux Contact)
32.4v 31.0v
31.8v 30.8v
31.2v 30.6v
30.6v 30.4v
30.0v 30.2v
INVERTER
SELECT
(Reset Alarm)
Set Equalisation
Voltage (Over Temp)
Set Absorption
Voltage (Overload)
Set Float Voltage (Batt High/Low)
Set Low Voltage (OFF)
CHANGE STATUS
(ON/OFF)
Absorption
Time
* To enter the programming mode hold down, the “Program” button and the “Change status” as shown
above, for minimum 2 seconds simultaneously.
* Press the “Select” button until the Red LED next to “Set Equalisation Voltage” is lit, then use the
“Change Status” button to select the value you require as indicated on the 5 centre LED’s.
User Manual COMPACT Rev 0803
SSC-1601A
Page 19