Sony DSR-570 - Best Broadcast Hire, BBH

2-9-6. AT-150B Board
1. Remove the left panel and cassette compartment lid.
(Refer to Section 2-2-1.)
2. Disconnect the connector CN503 from the AT-150B
board and remove the two screws (B2.6 x 4).
3. Disconnect the CN-1811 flexible board from the AT-
150B board. While picking the two board hinge clips,
remove the AT-150B board.
4. Return the board to its original position with the
reverse procedures of removal.
Point to notice when attaching the board:
Align the board hinge clip with hole.
When removing, take care that the connector of CN-1811
board is not twisted.
B2.6 x 4
CN-1811
AT-150B board
CN-503
Hinge clip
2-9-7. VA-190 Board
1. Open the right panel. (Refer to Section 2-2-2.)
2. Disconnect the flat cable (CN4) and the three
connectors (CN1, CN2, and CN3) from the VA-190
board.
3. Remove the two screws (B2.6 x 4). While picking the
board hinge clip, remove the VA-190 board.
4. Return the board to its original position with the
reverse procedures of removal.
CN1
Point to notice when attaching the board:
Align the board hinge clip with hole.
B2.6 x 4
CN2
CN4
CN3
VA-190 board
Board hinge clip
Hole
2-18
DSR-570WS/570WSP V1