Technical Manual UK.indd - CTC

electronic
Coded Keypad CSM 100
Connection / Operation - Programming
Code locking module optionally with an operation code number of 2, 3 or 4 digits.
The F code number (operation code number) is the secret code used in order to activate the contact with
the switch (door opening contact).
After entering the last digits, you have 5 seconds until the contact with the switch is activated. There is
one contact for opening and one contact for closing (1x UM).
The F code may be changed at any moment, while it is made up of 2, 3 or 4 (0-9) digits.
The P code (programming code) is required in order to change the F code or the P code.
Caution: It is advisable that you change the P code (factory setting) and keep the notes with the
new code in a safe location.
2
1-
220 V
+
LOCK
0 8V
VT 12
Transformer
12V~/1,4A
P code modification
1 4 7 2 5 8
#
0 4
#
1 2 3 4 5 6
#
1 4 7 2 5 8
#
0 3
Operation code
#
1
#
2
P-Code factory setting
147258
Entering of present code
Code P 147258
Operation code
Entering of new code
F code modification Factory setting Code P 1234
3 4
Entering of 6-digit code P
Entering of new code F
-5 seconds after connection to voltage, the device will be ready
for operation
-The pause between digits should not last more than 3 seconds
-In case you have forgotten the P code, contact the client service
department Tel.: 210 9718692
Technical specification:
Operating voltage 8-18 V AC/DC Operating current 1 mA/20mA
Link contact max. 40V/ Operating temperature – 25 to +50°C
14
For instance …Entrance to a
particular space should be protected
by means of a secret code.
Code F= 2549
The programming code
should be changed to
Code P = 264893
Code P modification
147258
#
04
#
264893
#
Modification of code F
264893
#
03
#
2549
#
14