âkatâÂ® carriage compact oscillator system - All Categories On Gullco ...

More documents

Recommendations

Info

The sequence of level 1 (General Programming Mode) program screen displays is as follows: Rotate the A rotary switch clockwise to move forward through the screens. Rotate the A rotary switch counter-clockwise to move backwards through the screens. 12
The Features & Setup Screen 1 st Field 2 nd Field 3 rd Field 4 th Field 5 th Field 6 th Field The Features & Setup Screen has the following features: 1 st Field = The Auto Cycle storage number to be recalled. The number shown in this field will be the program that will be copied from storage and applied to the running (operational) mode values when exited from programming mode. The choices are 0, 1, 2, 3, 4, 5, 6, 7, 8, 9, or 10 (surrounded by the auto cycle symbol). When the value is 0, the existing oscillation values last used will not be over-written. Each time the Features and Setup screen is opened, the value in this field defaults to 0. 2 nd Field = The Oscillation mode. There are three pictorial modes to choose from: ‣ Normal Oscillation. This is where the travel carriage is allowed to run continuously through the oscillation cycles. This is the factory default setting. ‣ Step during Dwells. This is where the travel carriage is only allowed to run during each of the A, B or C location dwells. This mode will only work effectively if the dwell times are not too small. ‣ Step during Oscillation stroke. This is where the travel carriage is only allowed to run during each oscillation stroke (i.e. carriage is not permitted to run during each of the A, B or C location dwells). This mode will only work effectively if the dwell times and the oscillation width are not too small. 13
Page 1: “KAT”® CARRIAGE COMPACT OSCILL
Page 4 and 5: SAFETY PRECAUTIONS The following ca
Page 6 and 7: or any unregulated 24 VDC power sup
Page 8 and 9: WARNING! The motor and oscillator c
Page 10 and 11: OSCILLATOR CONTROL A highly sophist
Page 12 and 13: command is released to the “KAT
Page 16 and 17: 3 rd Field = Travel Motion Delay. T
Page 18 and 19: ERROR CODES Error codes are display
Page 20: www.GULLCO.com

âkatâÂ® carriage compact oscillator system - All Categories On Gullco ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?

âkatâÂ® carriage compact oscillator system - All Categories On Gullco ...