Maytag - Neptune Washer Webinar - MSAWorld.com

More documents

Recommendations

Info

Slide 67 Direct Drive Motor Slide 68 Loosen screw on vent hose clamp and remove Insert stop Use a tool with a rubber coated handle to prevent damage Remove the vent tube and rotate the spinner. Locate one of the three slots in the spinner. Insert a suitable tool to use as a stop. Rotate the spinner in the direction you will be turning the rotor nut until it locks in place Rotate spinner until spinner is locked in position 32
Slide 69 Remove 19mm nut Torque Spec. 32-47 ft. lb. Slide 70 Grasp the rotor at the 9 and 3 o’clock position and pull The magnets make the removal of the rotor difficult 33
Page 1 and 2: BOOK #1
Page 3 and 4: Slide 4 Maytag Neptune Washer MAH97
Page 6 and 7: Slide 7 The installation process fo
Page 8 and 9: Slide 11 Install the filler plugs s
Page 10 and 11: Slide 14 MAH 8700 Slide 15 MAH8700
Page 12 and 13: Slide 18 ATC Control When ATC cold
Page 14 and 15: Slide 20 Removing the Top Slide 21
Page 28 and 29: Slide 51 The “power on” actuati
Page 30 and 31: Slide56 Counter Weights Fill Hose H
Page 32 and 33: Slide 61 - Heating Element Slide 62
Page 36 and 37: Slide 71 Warning: Do not place fing
Page 38 and 39: Slide 75 - Drain Pump Removal Slide
Page 40 and 41: Slide 81 Remove the 13mm bolts secu
Page 42 and 43: Slide 85 Remove the front struts an
Page 44 and 45: Prepare console back guard for remo
Page 46 and 47: Slide 93 Remove screws on back guar
Page 48 and 49: Slide 106 There is no belt adjustme
Page 50: T ROUBLESHOOTING INFORM ATION CODES

Maytag - Neptune Washer Webinar - MSAWorld.com

Create successful ePaper yourself

Delete template?

Save as template?