ZE-NC2010 Installation Guide Software Update - Zenec

More documents

Recommendations

Info

Installation Teil 2_MPEG a) Plug in the second USB data carrier labeled 2nd „MPEG Update“ with your ZE-NC2010 and again choose USB as data source. b) Now the unit should display a confirmation that it has found an MPEG software. Continue by pushing „UPDATE“ c) This part of the update will approximately take two minutes. As a pitfall during this step, it is technically not possibly to confirm this partial update (in case you never applied any update to your unit before). Therefore it is mandatory, that you let the second partial update run for at least two minutes. If this is not a first time update your unit will, however, confirm the succesfull completion of the process by displaying the respective on-screen message. First time updaters will not see the message, but still have to restart the unit by switching it off and on again. d) Now remove the USB-stick from the media-link-box. e) Load the factory defaults by pushing (Setup > Diverse > Zurücksetzen > Ja). The unit is now in delivery condition. Re-adjust your local language and continue with part three. 3. Installation Part 3 -> Application a) Connect the USB data carrier labeled 3rd „APP Update“ to your ZE-NC2010. b) Go to the setup menu and choose „Misc“ from the menu. On page two (you reach it by pressing the arrow in the lower left corner) choose „Software Update“ and confirm by pushing „YES“. c) The unit will now confirm that is has found a new application software update. Continue by pushing „UPDATE“. d) This part of the update takes approximately 1.5 minutes. The status of the process is displayed by a progress bar. e) After finishing the update, switch the unit off. 2 of 3 12.02.2010 JL / Uwe Morath, Product Development
4. Activation of the updates a) Now reset the unit to factory defaults: (Setup → Misc →Load Factory → Yes). Installation of the four software updates replaces the entire application software of the ZE-NC2010 and all your previous custom adjustments will be lost. You will have to redo them manually. b) We recommend to restore the AF function when in tuner mode. d) This update won’t touch the bluetooth and CAN-bus part of the firmware, which have to be installed separately if necessary. 5 Version check After you applied all four software updates you need to perform a version check: (Setup > General > Page2 > Version..........). Only the version numbers of MCU, MPEG and APPS are of interest. The software status after succesfull updates should look like the following: APP_V 2.88.5_0311_100129 MPG_V 2.1.88_0311_100126 MCU_V 2.2.72_0311_100129 The display of „ADP:….“ after the version number of the MCU signifies the software status of the CAN bus interface. If any deviation from the above mentioned status should occur, you can fix it by reapplying the respective part of the software. After doing so, reassure yourself by repeating the version check until you get the desired result. CAUTION : If one or even more of the partial updates fail, you may encounter strange erratic behaviour of your unit. Therefore version check and , in case of version check failure, reinstallation of the respective firmware parts are absolutely mandatory. Remark concerning password If you changed the default code of the theft protection please note that this also has been reset to factory defaults ( now you have to enter four times zero instead of your custom password). Unlock Depending on your previous software version, your device might lock itself after the MCU update process. Don´t panic, that´s not a big deal: Try „0000“ to unlock and if that´s not going to help push „SRC and“MUTE“ simultaneously until you get the onscreen message „ENTER SUPERCODE“. Now type „123456“. Done. 3 von 3 12.02.2010 JL / Uwe Morath, Product Development
Page 1: ZE-NC2010 Installation Guide Softwa

ZE-NC2010 Installation Guide Software Update - Zenec

Create successful ePaper yourself

Delete template?

Save as template?