Xirrus I-Beam Mounting Kit For XN4, XS4 And XS-3500 ... - Moonblink

More documents

Recommendations

Info

I-Beam Mounting Kit Installation Guide Attach Array Mounting Plate to Bottom Plate The Array mounting plate (supplied with the Array) must be fastened to the I-beam mount’s bottom plate. There are two types of bottom plate as shown below, but the procedure is the same for both. XE-2100 4-Port Array Mounting Plate installed on Bottom Plate: for XS4 and XS-3500 XE-2120 8/16-Port Array Mounting Plate installed on Bottom Plate: for XS8/16 and XS-3700/3900 1. Line up the Array mounting plate with the mounting holes on the bottom plate of the I-beam mount. (Orientation of the Array mounting plate with respect to the Array’s abg2 radio is not a concern—it may be changed by rotating the bottom plate with respect to the down rod.) 2. Using the four supplied 1/4-20 x 3/4” bolts, secure the mounting plate to the bottom plate (4 places, as shown). Tighten to 10-12 lbf.ft (1.38-1.66 kgf.m). Do NOT over-tighten the bolts or the plate may be damaged. 3. Attach the bottom plate to the threaded end of the down rod, screwing it on firmly. Make sure that the union ring is screwed down tightly. Down Rod Union 4. The down rod is furnished with the collar at the top assembled. If you disassemble it, reassemble it as follows: Important! The pin goes through the two larger holes at the top of the rod, and the collar slides up to seat the pin in slots inside the collar. Tighten the set screw, ensuring that is seated in the set screw hole, as shown on the right. Bottom Plate Set screw hole Pin Set screw Collar Note to the installer: It is critical that this component be assembled correctly, as the full weight of the assembly is supported by the pin, not the set screw. 4
I-Beam Mounting Kit Installation Guide Suspend the Down Rod 1. Hang the down rod from the I-beam by seating the down rod’s collar in the black cup under the I-beam bracket. 2. Secure the rod to the beam with the security chain. Fasten the clamp at the end of the chain to the I-beam as shown on the right. Using a crescent wrench (or an appropriate open ended wrench), tighten the square head bolts on top of the clamp to hold the clamp in place. 3. Verify that the clamp attaching the chain to the rod is tightly fastened. 4. If you need to adjust the orientation of the mounting plate, you may slightly loosen the union ring above the bottom plate (see the Bottom Plate Assembly on page 2), and rotate the plate. Secure the union ring tightly when you are done. Connect Data and Power Cables 1. Feed the cables through the mounting plate for 8- and 16-port Array models, then connect the cables to the Array. 2. When the cables are connected, turn on the power switch—before attaching the unit to the mounting plate (next step). Verify that the Ethernet link LED lights and the LED boot sequence begins. The radio LEDs on the front of the unit will illuminate in rotation, indicating that the Array software is loading and the unit is functioning correctly. Attach the Array to the Mounting Plate 1. Gently align the Array with the key post on the mounting plate, then turn the Array to the right to lock the unit into place at the 4 lugs— similar to a smoke detector. Key post Alignment hole Lug 5
Page 1 and 2: I-Beam Mounting Kit XE-2100/2120 In
Page 3: I-Beam Mounting Kit Installation Gu

Xirrus I-Beam Mounting Kit For XN4, XS4 And XS-3500 ... - Moonblink

Create successful ePaper yourself

Delete template?

Save as template?