ITEC-MULTIMIX 8/4 digital - Hardware
ITEC-MULTIMIX 8/4 digital - Hardware
ITEC-MULTIMIX 8/4 digital - Hardware
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>MULTIMIX</strong> 8/4 DIGITAL<br />
The voltage for phantom power on pin 6 is 12 Volt. By using the plug modules<br />
<strong>ITEC</strong>-MM-Ph-24 and <strong>ITEC</strong>-MM-Ph-48 respectively you can achieve higher phantom<br />
voltages.<br />
Attention: When using 48 Volt phantom voltage, short-circuiting the input signal wires on<br />
ground must be avoided.<br />
8) External control inputs:<br />
15-pole Sub-Min-D-socket on the housings rear panel, called ”EXT.CONTROL“.<br />
volume remote control:<br />
A simple volume remote control becomes possible by using the control inputs „External“.<br />
The 8 control inputs can be activated with external potentiometers and a control DC of<br />
0 -10V respectively. It is your choice (see software description) which input channels you<br />
decide to control.<br />
Configuration change:<br />
The same socket houses the control inputs for a configuration switch. External switch<br />
contacts activate one of the 15 predetermined settings.<br />
Socket allocation:<br />
8 a) External potentiometer:<br />
9<br />
1….External1 9 …External2<br />
2….External3 10…External4<br />
3….External5 11…External6<br />
4….External7 12…External8<br />
5.... +10 Volt 13…GND<br />
6....Config.1 14...Config.2<br />
7....Config.4 15...Config.8<br />
8....GND<br />
EXTERNAL POTENTIOMETERS<br />
Ext pot 1<br />
Ext pot 8<br />
www.itec-audio.com <strong>MULTIMIX</strong> 8/4 DIGITAL