Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
ACQUAINTANCE WITH TRACTOR<br />
E730a<br />
*AIR FILTER WITH ACTIVE CARBON<br />
Filters with active carbon are installed instead of <strong>the</strong> standard dust filter and<br />
replacement is carried out in <strong>the</strong> same way as in <strong>the</strong> common filters. The filter<br />
should be located with <strong>the</strong> white surface on <strong>the</strong> grid. Installation directions are<br />
stated in <strong>the</strong> chapter “Instructions for Maintenance”.<br />
The filter is used only when spraying pesticides, after <strong>the</strong> work <strong>the</strong> paper filter should<br />
be reinstalled, because <strong>the</strong> carbon filter would be choked with dust after a short period<br />
of time. Upon work <strong>the</strong> re-circulation controller should be in <strong>the</strong> position “air is<br />
drawn into from <strong>the</strong> outside”.<br />
The fan controller should be in <strong>the</strong> position “fan maximum work”.<br />
• WARNING: The filter does not provide full protection against toxic substances.<br />
• When handling <strong>the</strong> filter, wear protective gloves.<br />
• Don’t clean <strong>the</strong> filter; don’t flush it with compressed air.<br />
DANGER: The filter with active carbon should be replaced after every 200 hours or<br />
36 months (manufacture date is stated on <strong>the</strong> filter). If you can smell pesticides in <strong>the</strong><br />
cabin, replace <strong>the</strong> filter immediately and check <strong>the</strong> cabin sealing. Used filters should<br />
be disposed in special disposal centres.<br />
When spraying pesticides and<br />
using <strong>the</strong> heating filter with active<br />
carbon, <strong>the</strong> re-circulation controller<br />
should be in position “air is<br />
drawn into from <strong>the</strong> outside” and<br />
<strong>the</strong> fan controller should be in <strong>the</strong><br />
position “fan maximum work” to<br />
create overpressure in <strong>the</strong> cabin.<br />
25