D396-20-880 EXC100E-L turbo controller

More documents

Recommendations

Info

2.5 Logic interface Remote control signals Control voltage: low (close) < 0.8 V d.c. Control voltage: high (open) 4 to 24 V d.c. Maximum input current (at 24 V) 80 µA Maximum output current (at 0 V d.c.) 160 µA Air-cooler electrical supply Voltage range +20 to +26 V d.c. Maximum output current 150 mA Vent-valve electrical supply Voltage range +16 to +26 V d.c. Maximum output current 80 mA Analogue output Output voltage 0 to +10 V d.c. proportional to speed or power: 0 to 10 V ≅ 0 to 100% of pump speed, or 0 to 10 V ≅ 0 to 80 W motor power Maximum output current 5 mA TMP Normal and TMP Fail status outputs Maximum output voltage (high) 26 V d.c. Maximum output current Vout (low) ≥0.8 V 20 mA Vout (low)
A B C Rear view Top view Side view 1. Clearance for ventilation 2. Clearance for cables 3. Optional mounting plate Figure 2 - Dimensions (mm): EXC100E shown EXC Turbomolecular Pump Controllers 11
Page 1: D396-20-880 Issue F Instruction Man
Page 4 and 5: Section Title Page 4 OPERATION 22 4
Page 6 and 7: iv EXC Turbomolecular Pump Controll
Page 8 and 9: 1.2 Description The EXC Controller
Page 10 and 11: 1.4.2 Electrical supplies Two nomin
Page 12 and 13: 1.5.2 Vent on Stop If Vent on Stop
Page 14 and 15: 1. Electrical supply connector 2. E
Page 18 and 19: 3 INSTALLATION 3.1 Unpack and inspe
Page 20 and 21: 3.2.3 Enable/disable the Internal T
Page 22 and 23: Pin number Signal Polarity* Signal
Page 24 and 25: 3.5 Connect the electrical supply W
Page 26 and 27: 3.9.2 Connect a vacuum gauge to the
Page 28 and 29: 4 OPERATION 4.1 Start-up Notes: If
Page 30 and 31: 4.8 Electrical supply failure If th
Page 32 and 33: 6 STORAGE AND DISPOSAL 6.1 Storage
Page 34 and 35: 7.3.2 Pump-to-controller cable A pu
Page 36 and 37: A B C D EXT pump EXT connector on c
Page 38: 32 EXC Turbomolecular Pump Controll

D396-20-880 EXC100E-L turbo controller

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?