Installation Guide - WEBÂ·HOME - Danfoss.com

More documents

Recommendations

Info

WEB·HOME - Step 1 • Not on a wall where it will be subjected to direct sunlight. • Not on a wall where it will be covered by curtains, towels etc. hanging in front of the thermostat. • Devireg 550 must not be installed in small rooms with insufficient ventilation, such as bathrooms. In these cases the thermostat must be placed outside the room and a floor sensor (FS) used instead. • Not on a wall facing the outside.
I n s t a l l a t i o n G u i d e - W E B · H O M E Install Devireg 550 thermostat 1 2 step step 1 Remove the front cover by gently pressing the release tab in the top (center hole). 2 Lift off the cover. 3 Unscrew the two screws, one in each side. 4 Gently pull off the display module. 3 4 step step 5 Remove the frame from the thermostat. 5
Page 1 and 2: Article: 08090696 Version: 01.01 ww
Page 3 and 4: I n s t a l l a t i o n G u i d e -
Page 5 and 6: step I n s t a l l a t i o n G u i
Page 7: I n s t a l l a t i o n G u i d e -
Page 59 and 60:
I n s t a l l a t i o n G u i d e -
Page 61 and 62:
Page 63:
show all

Installation Guide - WEBÂ·HOME - Danfoss.com

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?