Download in PDF format - ATS
Download in PDF format - ATS
Download in PDF format - ATS
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
The Independent Solution Provider for Industrial and Process Automation, Quality & IT<br />
What's New <strong>in</strong> <strong>ATS</strong> Inspect 5.5<br />
www.ats-<strong>in</strong>spect.com<br />
New Features <strong>in</strong> <strong>ATS</strong> Inspect 5.0<br />
Adm<strong>in</strong><br />
1. Direct Run<br />
Due to customer requests, a new series of Direct Run reports have been added, driven by rout<strong>in</strong>g<br />
decisions made at key "gat<strong>in</strong>g" po<strong>in</strong>ts <strong>in</strong> the plant. The <strong>in</strong>tent of such report<strong>in</strong>g is to measure<br />
production efficiency to capture the number of units that go "offl<strong>in</strong>e" versus units that cont<strong>in</strong>ue on the<br />
normal production path.<br />
Even though the rout<strong>in</strong>g capability is already present, the reports who make use of this data will be<br />
available <strong>in</strong> the upcom<strong>in</strong>g ARS.<br />
Direct Run Hit =<br />
NO<br />
Unit goes offl<strong>in</strong>e for audit,<br />
part shortage that is<br />
supplier <strong>in</strong>duced, etc.<br />
Unit is OK, follows normal<br />
production flow.<br />
Direct Run Hit =<br />
NO<br />
Unit goes offl<strong>in</strong>e for repair,<br />
missed process, etc.<br />
Direct Run Hit =<br />
YES<br />
2. Defects per Unit<br />
Due to customer request we have added a series of reports that show <strong>in</strong><strong>format</strong>ion based upon<br />
defects per unit (DPU):<br />
Total Defects / Total Units<br />
These reports require that certa<strong>in</strong> defects not be counted <strong>in</strong> the DPU reports. The criteria for<br />
exclud<strong>in</strong>g defects <strong>in</strong>clude:<br />
<br />
<br />
Type of Defect – filters can be set for Concern, Concern + Part comb<strong>in</strong>ations, etc. Wildcards<br />
are allowed.<br />
Responsible Area – filters can be set for areas that should not be counted. For <strong>in</strong>stance<br />
there might be a "Supplier" area configured for Data Collect. Defects charged to such an<br />
area should not be counted as they are the fault of the supplier.<br />
Page 44<br />
www.ats-global.com<br />
<strong>ATS</strong> International B.V. © 2012 The <strong>in</strong><strong>format</strong>ion <strong>in</strong> this document is the property of <strong>ATS</strong> International B.V. and may not be copied, or communicated to a third<br />
party, or used, for any purpose other than that for which it is supplied without the express written consent of <strong>ATS</strong> International B.V.