Siemens LV Motors Manual - Rotor UK
Siemens LV Motors Manual - Rotor UK
Siemens LV Motors Manual - Rotor UK
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Mounting, installation<br />
5.3 Connecting<br />
Protruding connection cables<br />
CAUTION<br />
It must be ensured that there are no foreign bodies, dirt or moisture in the terminal base of<br />
the machine housing.<br />
Entries in the cover plates (see DIN 42925) and other open entries are to be sealed with an<br />
O ring or a suitable flat gasket so that dust and water cannot enter, whereas the terminal<br />
base of the machine housing itself is to be sealed against dust and water with the original<br />
seal of the cover plate. Observe the correct tightening torque for cable glands and other<br />
screws. Secure the featherkey for a test run without drive elements.<br />
WARNING<br />
During disassembly and particularly when installing the cover plate, ensure that the<br />
connection cables are not clamped between enclosure parts and cover plates. Short-circuit<br />
hazard!<br />
Connecting the temperature sensor/anti-condensation heater<br />
The temperature sensor / anti-condensation heater is connected in the terminal box.<br />
Figure 5-1<br />
Connection to terminal strip<br />
Figure 5-2<br />
Connection to terminal board<br />
1LA5/6/7/9, 1LP7/9, 1PP6/7/9, 1MA6/7, 1MF6/7, 1MJ6, 1LE1<br />
42 Operating Instructions, 10/2008, 5 610 00000 02 000
Change language