Service manual FastMig MXF feeders version 2.0 - Rapid Welding ...

More documents

Recommendations

Info

Welding panel card P001 layout FUNCTION BUTTONS BUS CONNECTOR X1 SEVEN SEGMENT DISPLAYS JUMPER CONNECTOR (FOR FUTURE PURPOSES) PULSE POTENTIOMETERS J-TAG CONNECTOR FUNCTION BUTTONS SEVEN SEGMENT DISPLAY MICROPROCESSOR
Welding panel card P001 connectors and testing PF65 (X1) and P65 (X1) CAN bus interfaces are identical. Both Panels use CAN interface and KeBus protocol. Connector/pin X1/1 X1/2 X1/3 X11/4 X1/5 X1/6 X1/7 X1/8 X1/9 X1/10 X1/11 X1/12 X1/13 X1/14 X1/15 X1/16 Connector type Pin header, 2.54mm Pin header, 2.54mm Pin header, 2.54mm Pin header, 2.54mm Pin header, 2.54mm Pin header, 2.54mm Pin header, 2.54mm Pin header, 2.54mm Pin header, 2.54mm Pin header, 2.54mm Pin header, 2.54mm Pin header, 2.54mm Pin header, 2.54mm Pin header, 2.54mm Pin header, 2.54mm Pin header, 2.54mm Description Not connected Not connected Not connected Not connected WF number CAN transfer GND CAN receive Not connected Not connected Not connected Not connected Not connected Not connected +5VDC GND When panel starts all LEDs light and all the display segments should be on, during this period of any of the buttons are pressed, all led light turn off and panel software version number is shown in display. This function can be used to test the panel buttons and LEDs/displays. This test mode is only possible when panel is starting
Page 1 and 2: Service manual FastMig MXF feeders
Page 3 and 4: Electrostatic Discharge Electrostat
Page 5 and 6: General service procedure It is rec
Page 7 and 8: Motor Control Card A001 layout X12
Page 9 and 10: Motor voltage Motor voltage can be
Page 11 and 12: Gas valve control Gas valve control
Page 13: Motor control card A001 connectors
Page 17 and 18: Sync card A004 voltages SuperSnake
Page 19 and 20: Construction, right side DT400 WIRE
Page 21 and 22: Fastmig Pulse compatibility Fastmig

Service manual FastMig MXF feeders version 2.0 - Rapid Welding ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?