Torqeedo Ultralight 402

More documents

Recommendations

Info

4. Assemble the drive by clamping the ball receiver to the mounting ball. For this the boom must be aligned horizontally to the water line. When tightening the screws in the ball clamp, ensure that the gap on both sides of the clamp is the same distance. 5. If desired, mount the rubber rest on the second motor resting point. Select the desired location and use the spacers supplied to balance out the height. Attach the rubber rest in the same fashion used to attach the ball mount by using two screw anchors. Fix boom to the rubber rest using the elastic cord. 1. 2. Elastic cord Spacer 6. Loosen the screws on the two clamping rings and position the motor so low that the propeller does not draw air even at full throttle. Then retighten the two screws. Ensure that the upper clamp ring is perpendicular to the propeller axis. 18 Operating Manual Ultralight 402
8. Starting up • If you are unsure about the position and assembly of your motor contact your Torqeedo dealer. • Ensure that when tilting the motor the cables are not crimped. 8.2 Commissioning the tilting device 1. Mount a clamp block at the level of the driver’s seat. Position the clamp block so that it will hold a line if it is pulled towards the stem of the kayak. 2. Cut the supplied line to 2 x 3 m (10’) and 2 x 0.5 m (2.5’). Melt the ends e.g. with a lighter. 3. Firmly tie one of the 3 m (10’) lines to the top of the swing arm. Guide the line through the loop on the ball clamp and fix it in the clamp block. In this way you have the opportunity to tilt the motor out of the water and to hold it in the tilted position. 1. 2. 4. If you want to use the motor in reverse, mount the second clamp block and guide the line to the lower end of the pivot arm. This protects the motor from undesired tilting up. 8.3 Attaching the steering The following steps are only relevant if you want to connect the motor to the kayak’s steering system. 1. If you want to connect the motor with the kayak’s steering system instead of the rudder: Fix the lines from the kayak’s steering with the triangular clamp ring at the upper end of the motor shaft. Extend the lines for the kayak’s steering as far as necessary, if appropriate you can use the supplied snap hooks to fix the lines to the clamp ring. Operating Manual Ultralight 402 19
Page 1: Ultralight 402 Operating Manual (En
Page 4 and 5: 2. Important safety and operating i
Page 6 and 7: 3. Introduction Dear customer, We a
Page 8 and 9: 6. Warranty conditions 6.1 Extent o
Page 10 and 11: 7. Equipment and operating elements
Page 12 and 13: 8. Starting up 8.1 Attaching and al
Page 14 and 15: C Fixing the motor to the kayak’s
Page 16 and 17: Take the screws out of the screw an
Page 20 and 21: 2. If you want to connect the motor
Page 22 and 23: • The battery is protected from w
Page 24 and 25: only start the motor again if you f
Page 26 and 27: • For reverse movement the fixing
Page 28 and 29: Fault codes Display Cause What to d
Page 30 and 31: • The pylon may be hot. • Ensur
Page 32 and 33: 12. Trouble shooting Motor does not
Page 34: 14. Disposal instructions Torqeedo

Torqeedo Ultralight 402

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?