U-Panel Product Information - McElroy Metal

U-PANEL
U-PANEL PURLIN BEARING PROFILE
36” Coverage
6” (typ.) 1 1/32”
47/64”
2 15/32”
U-Panel
U-PANEL NON- PURLIN BEARING PROFILE
39 1/4”
U-PANEL NON- PURLIN BEARING PROFILE
6” (typ.)
36” Coverage
1 1/32”
36” Coverage
6” (typ.) 1 1/32”
47/64”
2 15/32”
37 3/16”
47/64”
2 15/32”
37 11/16”
Master Coil Width: 40 7/8” (29 GA Only) Master Coil Width: 41 9/16”
U-Panel Load Tables and Section Properties
Load tables and section properties for U-Panel can be found online at www.mcelroymetal.com. Please contact the
McElroy Technical Service Department at 1-800-950-9082 for additional information.
Notes:
- Standard Panels:
- 26 gauge Galvalume ® ®
substrate with Kynar 500 coating or siliconized polyester coating.
- 24 gauge Galvalume ® ®
substrate with Kynar 500 coating.
- 29 gauge Galvalume ® ®
substrate with Kynar 500 coating or siliconized polyester coating.
- U-Panel with pulin bearing leg is run out of grade 80 material.
- Minimum Slope:
- 2:12 minimum roof slope without sealant tape.
- Standard minimum length is 3’ and standard maximum length is 50’.
- Additional fees may apply for panel lengths under 3’ and over 50’.
- Standard trim is 26 gauge.
- Oil canning is inherent in all metal panels and is not cause for panel rejection.
- Contact a McElroy representative for specific pricing, lead times and special colors or gauges that may not be on a McElroy Metal
color chart.
- Contents of this manual are subject to change without notice. To confirm this manual is the most current copy, visit www.mcelroymetal.com.
1