Swipe-N-Clean 1.0 Complete - Jim Coleman Company
Swipe-N-Clean 1.0 Complete - Jim Coleman Company
Swipe-N-Clean 1.0 Complete - Jim Coleman Company
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>Swipe</strong>-N-<strong>Clean</strong> Operating Manual<br />
INSTALLATION<br />
Please read this whole section prior to starting installation. The steps are critical to a successful<br />
installation of the SNC.<br />
Cabinet Installation<br />
44" Faceplate Heigth<br />
Figure 1<br />
The following drawing is a typical cabinet pattern for mounting.<br />
40" Cabinet Heigth<br />
IV-2<br />
. . . . . . . . . . INSTALLATION<br />
27" Faceplate Width<br />
25" Cabinet Width<br />
34" Cabinet Mounting From<br />
Concrete Finish<br />
Faceplate Dim.<br />
27’ x 44”<br />
Cabinet Dim.<br />
25” x 40”<br />
Cabinet Bottom is<br />
34” above<br />
concrete level<br />
Concrete Level<br />
1. After cutting a hole in the wall for the SNC cabinet, insert cabinet into the wall<br />
from the front.<br />
2. Once cabinet is inserted in the hole - secure using the angle mounting brackets<br />
and bolts provided. (See Fig. 2)<br />
Note:<br />
Close tolerance should<br />
be maintained when<br />
cutting the mounting<br />
hole for the SNC<br />
cabinet. This will<br />
ensure a tight fit. A<br />
minimum amount of<br />
sealant or weatherstripping<br />
should be<br />
needed to make the<br />
cabinet weather proof.
Change language