TC65 AT Command Set

TC65 AT Command Set
10.3 AT^SISS
s
3 Retrieve command.
If value "pNumber" is set to a non-zero value this command
retrieves the related message from the POP3 server's maildrop list.
If no such message exists on the server the POP3 service issues an error
response to the user.
It depends on the parameter "pDelFlag" if the message will be deleted from the
POP3 server upon successful retrieval.
If value "pNumber" is zero the "Retrieve" command returns all
messages pending in the POP3 server's maildrop.
If there are no messages on the maildrop list of the server the POP3 service
returns with a positive response, i.e. it doesn't issue an error response, but the
returned list will be empty.
Each email will be finished by a so-called "dotline", i.e. a new line with just a
single dot.
4 Delete command
If value "pNumber" is set to a non-zero value the command
deletes the related message from the POP3 server's maildrop list. In fact, the
message is marked as deleted on the server and will be deleted permanently
if the POP3 service command executes successfully. In case an error has
occurred, e.g. network loss, the message will not be deleted on the server even
though the POP3 service command has been finished.
If value "pNumber" is zero the "Delete" command deletes all
messages from the POP3 server's maildrop list. In fact, the messages are
marked as deleted on the server and will be deleted permanently if the POP3
service command executes successfully. In case an error has occurred, the
messages will not be deleted on the server even though the POP3 service
command has been finished.
(num)
Supported flag values in for value "pDelFlag". Only applicable if the profile
contains the POP3 user command Retrieve ("3").
[0] Messages will not be deleted on the server.
1 Delete messages on the server which have been retrieved successfully.
Note
• String parameters are truncated if greater than the maximum length specified above.
TC65_ATC_V02.000 Page 270 of 567 6/2/06
Confidential / Released