TC65 AT Command Set

TC65 AT Command Set
18.19 AT^SRTC
s
18.19 AT^SRTC Ring tone configuration
The AT^SRTC read command returns the current and current . The read command can be
used while test playback is off or on. In the latter case, see execute command for details.
The AT^SRTC execute command is intended for testing. It starts to play a melody from the audio output currently
selected with AT^SNFS. To deactivate test playback use AT^SRTC again.
During test playback, you can enter the write command to select another melody and adjust the volume. Also,
you can enter the read command to check the type and volume of the current ring tone, and to view the status
of playback (on / off). The test ringing signal cannot be activated when an MTC is ringing (ERROR).
Selecting =0 during the test, immediately stops playback. After this, ring tones will be muted until you
change using the write command.
The AT^SRTC write command chooses the type and volume of ring tones. The settings can be changed no matter
whether or not the ME is ringing. The selected type and volume are saved in the non-volatile Flash memory and,
thus, are retained after Power Down. An exception is =0, that can be entered to quickly mute the tone or
melody currently played to indicate an event. =0 only stops immediately the audible ring tone, but does
not terminate the URC that indicates the event (for example RING). No permanent settings are changed or
saved.
Syntax
Test Command
AT^SRTC=?
Response(s)
^SRTC:(list of supported) s, (list of supported) s
OK
Read Command
AT^SRTC?
Response(s)
^SRTC: , ,
OK
Exec Command
AT^SRTC
Response(s)
OK
Write Command
AT^SRTC=[][, ]
Response(s)
^SRTC: ,
OK
ERROR
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge Last
SIEMENS ! % % % % % % ! % !
TC65_ATC_V02.000 Page 472 of 567 6/2/06
Confidential / Released