ABS LIFTING STATION SANIMAT 1000 S-1 (GB).indd

ABS LIFTING STATION SANIMAT 1000 S-1
Installation Example
1
Backwash loop with base
above the backwash level
1
1
Backwash level
2
3
Attention to the backwash level is of
vital importance for effective dewatering.
A backwash occurs if the sewer lines
are filled up completely due to heavy
rainfall. In this case the lines used for
the dewatering of buildings and sites
are filled up to the backwash level. All
outflow points located below the backwash
level must be protected against
back flow. According to standard (EN
12056) the backwash level is determined
by the local authorities. If no
information is available then in the case
of level ground the street surface at the
connection point may be taken as the
back-wash level. By street surface we
mean the roadway including paths, hard
shoulder, etc.
Accessories
Description (Materials) Size Part No.
Discharge side
1
Hand membrane pump G 1½” 14990028
with built-in non return valve for separate wall fixing
2
3
4
5
Shut-off valve (EN-GJL-250) DN 80 61420500
including 1 set of bolts and seal PN10
Inflow side
Inflow Adapter DN 100 41405002
(1 supplied as standard)
Flanged sleeve E-KS DN 100 62540025
transition piece DIN-flange/push-on sleeve including 1 set of bolts
and 1 flat gasket for vertical inflow
Flanged spigot (EN-GJL-250) 4”/DN 100 41400594
for horizontal inflow in conjunction with
shut off valve
Shut-off valve (EN-GJL-250) DN 100 61420501
including 1 set of bolts and 1 flat gasket, flange PN 16
Electrical accessories
Plug in alarm 16020201
NC-Battery for mains independant alarm 12820031
(can be fitted into the standard control panel Sanimat 1000 S-1
1
4
5
4
210061 GB 12.2006 ABS reserves the right to alter specifications due to technical developments.
| ABS Group | Tel. +46 40 35 04 70 | Fax +46 40 35 50 45 | info@absgroup.com | www.absgroup.com |