TEMPERATURE °CONTROLS - Temperature Controls

TCA TEMPERATURE SWITCH
• Head mounted 4 wire temperature switch
• Type K thermocouple input
• Mounts into standard Thermocouple terminal head with 40mm centres
• Power supply 18-30 V AC / DC Polarity protected
• Change over 10 Amp relay contact output Max : 32 Volt Resistive
• Range selection by solder pads 100, 200, 400, 600, 800 & 1200 Deg C
• Dead band 5% of set range
• Set point adjustable by 15 turn potentiometer
Model
Price
TCKHSW $190.00
Specify temperature set point
at time of order
SD 502
Drawing and Technical Data Sheet
Cartridge Thermostat
A thermosensitive Bimetallic element, in contact with the cartridge housing, actuates a pair of switch
members to open and close its' contacts in response to temperature change. Thermal strain relief is
incorporated to prevent calibration drift.
SD 616
Adjustable Range 0 to 250 °C
Normally Open or Normally Closed Contact models
Adjustable by screw in the hex nipple
Material = Brass
Rated up to 240 V AC 1200 Watts ( 5 A Resistive Load )
Stem Length 52 mm
MODEL DESCRIPTION PRICE
Thermowells available to suit
Temperature differential as low as 1 °C in ideal conditions TCFM171NC NORMALLY CLOSED UNIT $235.00
Terminal heads on opposite page may be fitted
TCFM171NO NORMALLY OPEN UNIT $235.00
Thermal Cut Outs / Protectors
Bimetallic Thermal switches suitable for use as Thermal Cut outs, Motor or Compressor over temperature protectors.
Normally Open Range
Normally Closed Range
Model No. Close at Re-open at
TCOP6170 70 o C 40 o C
TCOP6180 80 o C 50 o C
TCOP6190 90 o C 60 o C
TCOP61100 100 o C 70 o C
TCOP61110 110 o C 80 o C
TCOP61122 120 o C 85 o C
TCOP61130 130 o C 90 o C
TCOP61140 140 o C 100 o C
Assembly A
Assembly B
SD 1505
Model No. Open at Re-close at
TCUP6170 70 o C 40 o C
TCUP6180 80 o C 50 o C
TCUP6190 90 o C 60 o C
TCUP61100 100 o C 70 o C
TCUP61110 110 o C 80 o C
TCUP61122 120 o C 85 o C
TCUP61130 130 o C 90 o C
TCUP61140 140 o C 100 o C
Temperature Controls can fit the above switches into a stainless steel tube
9.5 mm diameter and terminate in DIN plug or Terminal head
Wire Feed thru for Pressure or Vacuum Applications
Transducer glands provide a seal on solid bare 24 awg Thermocouple Wires. The replaceable seal
allows for the fitting to be reused or an element replaced in the field. Applications include
Autoclave, Inert Gas Filled Furnace or Toxic Gas Furnace.
Temperature Range Minus 185 to + 870 °C, Pressure Range Vacuum to 690 Bar SD 1513
Units available to seal up to 16 Elements
MODEL DESCRIPTION PRICE
TG24B2T 2 Wire Single Element 1/4” NPT Connections $565.00
TG24B4T 4 Wire Duplex Element 1/4” NPT Connections $575.00
34.
Copyright 2009. Due to ongoing product development, prices and specifications are subject to change without notice.
Prices do not include GST.