oXYgen Scanning Application User Guide Addendum - Kodak
oXYgen Scanning Application User Guide Addendum - Kodak
oXYgen Scanning Application User Guide Addendum - Kodak
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Preparing the Mask for Reflectives<br />
To prepare the mask for reflectives, do the following:<br />
‣ Tape the reflectives to the reflective side of the mask, according to the format you want to<br />
define. Make sure the image side is up and oriented correctly.<br />
NOTE: The first original should be near the 0,0 point at the lower left corner of the mask.<br />
Taping the originals is similar to direct mounting in multi-preview (as described in this release<br />
note) but in this case you proceed from left to right. Make sure not to cover the barcode<br />
windows.<br />
To mount in the scanner:<br />
1. Turn the mask over so that the transparency label of the mask faces up.<br />
2. Place the mask registration holes over the registration pins of the glass.<br />
Defining user defined formats<br />
<strong>User</strong> defined formats must be defined in the application before you can use<br />
them. Once the mask you have prepared is mounted in the scanner, follow the<br />
procedure described below for both transparencies and reflectives.<br />
1. In the Setup dialog box, choose the All Board format.<br />
or<br />
• If the user defined mask does not cover the entire scanner bed, define the area you want to<br />
preview.<br />
2. Click Preview.<br />
The scanner performs the preview. The Image Display window appears showing all images<br />
on the scanner Base glass.<br />
3. Crop each window/original in the Preview Display window.<br />
The system automatically adds 1.5 mm around your crops.<br />
<strong>oXYgen</strong> <strong>Scanning</strong> <strong>Application</strong> - <strong>User</strong> <strong>Guide</strong> <strong>Addendum</strong> 15