LVPZT Amplifier Module - PI

More documents

Recommendations

Info

E-480, frequency response with various PZT loads. Values shown are capacitance in nF, measured in actual PZT. Technical Data Models E-480.00 Function Power amplifier (servo-controller option) Channels 1 Maximum output power 2000 W (see page 6-40) Average output power Equivalent to 630 W reactive power Peak output current < 50 ms 2000 mA Average output current > 50 ms 100 mA Small-signal bandwidth 5 kHz (660 nF); 1 kHz (3.4 µF) Large-signal bandwidth 1.4 kHz (660 nF); 350 Hz (3.4 µF) Current limitation Short-circuit proof Voltage gain -100 ±1, +100 ±1 (selectable) Polarity Negative/positive/bipolar (depending on connector configuration) Control input voltage 0 to +10 V, 0 to �10 V (jumper selectable) Output voltage -0 to �1000 V (-750 to +250, -500 to +500, -250 to +750, 0 to +1000 V, depending on connector configuration) Ripple Up to 0.3% (depends on voltage range and capacitance of PZT) DC-offset setting 0 to 100% of output voltage range, set with 10-turn pot. Input impedance 1M� Control input sockets BNC PZT voltage output sockets LEMO special connector Dimensions 450 x 158 x 288 mm (s. page 6-7) Weight 8.6 kg Block diagram of amplifier with power recovery Operating voltage 90-120 / 210-250 VAC, 50-60 Hz PZT Actuators PZT Flexure NanoPositioners PZT Active Optics / Steering Mirrors Tutorial: Piezoelectrics... Capacitive Position Sensors PZT Control Electronics MicroPositioners / Hexapod Systems Photonics Alignment & Packaging Systems Motor Controllers Index http://www.pi.ws info@pi.ws 6-27 6-27
Ordering Information E-463.00 HVPZT <strong>Amplifier</strong>, 3 Channels, Bench-Top Custom Designs for Volume Buyers 6-28 6-28 6-28 6-28 6-28 6-28 6-28 6-28 E-463 E-463.00 E-463, frequency response with various PZT loads. Values shown are capacitance in nF, measured in actual PZT. HVPZT <strong>Amplifier</strong>, 3 Channels http://www.pi.ws info@pi.ws � 3 Independent Channels � 3 x 5 W Peak Power � 3 LED Voltage Displays � Output Voltage Range 0 to -1500 V The E-463.00 is a bench-top amplifier for high-voltage PZTs. It contains three independent amplifiers that can output and sink a peak current of 4 mA and an average current of 3 mA each. The E-463.00 can be operated in two ways: I. Manual operation: Output voltage for each channel can be set by a 10-turn DC-offset potentiometer in the range of 0 to -1000 V. II. External operation: Output voltage is controlled by an analog signal applied to the BNC inputs, ranging from 0 to 10 V. Multiplying by the gain factor of -150, an output voltage range of 0 to -1500 V results. The DC-offset potentiometer adds a DC bias to the input, allowing continuous shifting of the input range between 0 V to +10 V and -6.66 V to 3.33 V (see page 6-40). Three 31 / -digit LED displays 2 show the output voltage of each individual channel. For frequency response with selected HVPZTs, see graph below. For computer-controlled closed-loop positioning electronics, refer to the E-500 system starting on page 6-20. Technical Data Models E-463.00 Function Power amplifier Channels 3 Maximum 5 W per channel output power (s. page 6-40) Peak output current < 5 ms 4 mA per channel Average output current > 5 ms 3 mA per channel Current limitation Short-circuit proof Voltage gain -150 ±1 Polarity Negative Control input voltage 0 to +10 V Output voltage 0 to -1500 V DC-offset setting with 10-turn pot. 0 to -1000 V at output Input impedance 1 M� Display 3 x 31 / -digits, LED 2 Control input sockets 3 x BNC PZT voltage 3 x LEMO output sockets ERA.0A.250.CTL Dimensions 235 x 103 x 288 mm (s. page 6-7) Weight 4.3 kg Operating voltage 90-120 / 220-240 VAC, 50-60 Hz (linear P/S)
Page 1 and 2: Motion Controllers, Drivers and Pow
Page 3 and 4: PZT Motion Controller Experience (c
Page 5 and 6: PZT Electronics: Motion Controllers
Page 7 and 8: Models Function Output Peak Output
Page 9 and 10: PZT Electronics Selection Guide Mod
Page 11 and 12: Ordering Information 6-8 E-710 E-71
Page 13 and 14: 6-9b NanoCapture TM Software for E-
Page 15 and 16: Ordering Information E-612.C0 High-
Page 17 and 18: E-750.CP controller with P-752 Nano
Page 19 and 20: E-760 E-760 controller card with P-
Page 21 and 22: E-665.SR Ordering Information E-665
Page 23 and 24: E-610 Notes Important Calibration I
Page 25 and 26: Ordering Information E-500.00 PZT-A
Page 27 and 28: 6-22 6-22 6-22 6-22 6-22 E-500 E-50
Page 29 and 30: Ordering Information E-470.00 HVPZT
Page 31: Notes Important Calibration Informa
Page 35 and 36: E-461.00 Ordering Information E-461
Page 37 and 38: Ordering Information E-650.00 LVPZT
Page 39 and 40: E-503.00 E-503 Ordering Information
Page 41 and 42: E-507.00 6-35 E-507 E-507.00, frequ
Page 43 and 44: Ordering Information E-516.i3 20-bi
Page 45 and 46: Ordering Information E-515.01 Displ
Page 47 and 48: PZT amplifiers without position ser
Page 49 and 50: E-115.21 dimensions (in mm) E-115.1
Page 51 and 52: Notes Unless stated otherwise, PI H
Page 53 and 54: 6-46 Recommended Amplifier/Controll
Page 55 and 56: E-621 open-loop frequency response
Page 57: Tiny: E-841.05/E-842.05 dimensions

LVPZT Amplifier Module - PI

Create successful ePaper yourself

Delete template?

Save as template?