OPERATOR'S MANUAL
OPERATOR'S MANUAL
OPERATOR'S MANUAL
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
To check level of gear box lubricant, place saw arm<br />
in down position and allow a few minutes to pass<br />
so that oil drains down. Check level in sight glass<br />
on side of gear casing. Correct level is the dot in<br />
the middle of sight glass.<br />
To change gear box lubricant:<br />
1. Disconnect machine from the power source.<br />
2. Open drain plug and allow lubricant to drain<br />
completely. Drain plug may be found on lower<br />
front of gear case under right wheel cover.<br />
Remove drain plug with a hex wrench.<br />
3. Replace drain plug.<br />
4. Remove filler cap (A - Fig. 12) and fill gear box<br />
with Mobil DTE@ Oil Heavy Medium until level<br />
reaches dot in middle of sight glass.<br />
5. Replace filler cap.<br />
6. Connect machine to the power source.<br />
Use a light machine oil to lubricate all other moving<br />
parts as needed<br />
A detailed explanation on blade selection and<br />
blade problems and their solutions can be found in<br />
the enclosed "Guide to Band Sawing" published by<br />
American Saw and Manufacturing Company. Used<br />
by permission.<br />
11<br />
Fig. 12