OPERATOR'S MANUAL
OPERATOR'S MANUAL
OPERATOR'S MANUAL
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Adjusting Vise Square to the Blade<br />
1. Disconnect the machine from the power<br />
source.<br />
2. Place a machinist's square on the table<br />
against the blade and the vise. The square<br />
should lie along the entire length of the vise<br />
and blade without a gap.<br />
3. If adjustment is necessary, loosen bolts<br />
holding the vise and adjust vise so square<br />
lines up properly. Tighten bolts.<br />
4. Connect machine to the power source.<br />
Changing Blade Speeds<br />
it. WARNING<br />
Disconnect the machine from the power source<br />
before making any repair or adjustment!<br />
Failure to comply may cause serious injury!<br />
1. Disconnect machine from the power<br />
source.<br />
2. Open pulley cover by supporting the belt cover<br />
with one hand while removing the belt cover<br />
lock knob with the other. Lower guard gently<br />
to its full open position.<br />
3. Support motor with one hand while loosening<br />
lock handle (A - Fig. 6). Lower motor gently.<br />
4. Position belt in grooves according to the speed<br />
selection chart.<br />
5. Tension the v-belt by pushing down on the<br />
motor and tightening the lock handle on the<br />
motor tilt plate. Correct tension is achieved<br />
when finger pressure on the belt between the<br />
two pulleys causes approximately a 1/2"<br />
deflection.<br />
6. Close pulley cover and fasten.<br />
7. Connect machine to the power source.<br />
5<br />
Fig. 6