Attachment 1 Statement of Work dated December 2012

More documents

Recommendations

Info

4.0 General NotesTORFP GJKZ 09-0063ATTACHMENT 1a. methods to be used to install the ground rodsb. methods used to repair the epoxy floor coatingc. methods used to extend the bonding conductor from the floor joint to the buildingsteel.d. method used to extend the bonding conductor from the building steel to thehangar bay service panel.4.1 All materials shall be non-toxic, certified free of lead and asbestos.4.2 All work sites shall be rendered safe to maximum extent possible.4.3 No hazardous materials shall be stored on site.4.4 Daily cleanup and removal of all demolished materials shall be done by end of each day.4.5 Scheduling of any utility outage of one hour or less shall be coordinated at a minimumof seven days in advance. Outages longer than one hour shall be required to have 14 daysnotice.4.6 All electrical work shall comply with the latest edition of NFPA 70: National ElectricalCode, as well as the workmanship standards outlined in ANSI/NECA 1-2000: StandardPractices for Good Workmanship in Electrical Contracting.4.7 The contractor shall ensure that all demolition waste materials (concrete waste, primer,epoxy coating) are disposed in accordance with all federal, state, and local environmentalrequirements. At no time shall these materials be allowed into the sanitary or storm watersystems. MSDS's shall be required to determine hazardous characteristics of the floorcoatings. The MSDS and Contractor HAZMAT Authorization forms shall be submitted perthe basic MATOC contract.5.0 LOCATION AND CONCEPT DRAWINGS:Drawings are included with the SOW appendices. It is the contractor’s responsibility toverify existing conditions and provide work that complies with all State and Federal codesand regulations.6.0 Specifications6.1 MATOC Specification, General Contract Provisions, Attachment 7 applies to thisProject.6.2 Upon award, submittal register and submittals applicable to this Task order arerequired.Page 4 of 5
TORFP GJKZ 09-0063ATTACHMENT 1Appendices:A. As Built Epoxy Floor Drawings Showing Dimensions PDF.B. As Built Epoxy Floor Drawings Showing Dimensions ACADC. FY 2011 Previous Project Joint Sealant Asbestos SurveyD. Epoxy Coating System Used on Hangar FloorE. Aircraft Static Ground Rod To Be Used Inside HangarsF. Ground Point LocationsPage 5 of 5
Page 1 and 2: STATEMENT OF WORKFORRepair Aircraft

Attachment 1 Statement of Work dated December 2012

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?