PHONECELL SX4e - RACOman.com

Originating Fax and Data CallsSending a Fax Message1) Set up your fax machine just as youwould for a wired telephone line.2) If your fax machine has a 'prefix'setting, set it to # * 2. If your programdoes not have such a setting,Telephone Cordadd # * 2 to the phone number asshown in the example below:Phone PortExample: If you are sending toFax Machine1-800-123-4567, enter#*218001234567. The '# * 2' tellsFigure 11 - Connecting a fax machine to the SX4e.the SX4e to use the analog mode forthis call only.3) Your fax should then proceed normally.NOTE: If the network does not haveanalog channels available, the call willbe unsuccessful. Try the call at a latertime.Sending Data1) Connect your computer modem tothe Phonecell SX4e exactly thesame way you would to wired telephoneservice.Telephone Cord2) If your modem communicationsprogram has a 'prefix' setting, set itPhone PortComputerto # * 2. If your fax machine doesnot have such a setting, add # * 2 Figure 12 - Connecting a computer to the SX4e.to the phone number as shown inthe example below:Example:If you are sending to 1-800-123-4567, enter #*218001234567. The '# 2' tells the*Phonecell to use the analog mode for this call only.3) Your data transmission should then proceed normally.NOTE: If the network does not have analog channels available, the call will be unsuccessful. Try thecall at a later time.NOTE: As a result of using this dial string prefix, the SX4e will be placed in the analog mode and ananalog channel will be requested before the call is dialed. If the request is successful, the data ratenegotiations will commence and the call will continue. The "FWT Status" LED will indicate an analogcall by flashing green.Receiving Fax and Data CallsWhen your fax machine or modem answers a call, the Phonecell will decode the answer tone fromthe local device. This will cause the Phonecell to go to analog mode, regardless of which mode iscurrently set, to receive the data or fax. The "FWT Status" LED will indicate an analog call by flashinggreen. You do not need to do anything to allow your unit to receive fax or data calls. However,the facsimile machine and/or computer data modem must be connected to the Phonecell SX. (See:Step by Step Fax Instructions). If the call is not completed successfully, the remote caller shouldretry the call immediately The Phonecell SX4e will remain in analog mode for a short time after callfailure waiting for retry.Refresh FWT to Digital ModeWhen the analog fax/data call ends, the "FWT Status" LED will return to continuous green indicatingthe FWT has returned to its normal operating digital mode.SX4e TDMA 800 • SX4e Tri-Mode 11 User Manual