Xilinx® Spartan®-6 FPGA LX9 MicroBoard

More documents

Recommendations

Info

9. Type ‘debug’ to test all the peripherals. It is expected to get failures for the Pmod loopback testssince the loopback connectors are not installed. If you are interested in designing your own loopbackconnectors, the diagrams are available on the DRC for the Spartan-6 LX16 board.www.em.avnet.com/s6microboard10. Close the terminal11. This concludes the HyperTerminal Demo.16 Getting Started with the Xilinx Spartan-6 LX9 MicroBoard Version 1.1
WebServer DemonstrationThe default FPGA design also includes a WebServer application. To run this application, you may have toconfigure the network properties on your PC. The following steps will guide you through this process.1. Attach an standard Ethernet Cable between the MicroBoard and the PC.2. Open Network Connections.Start è Control PanelSelect Network Connections3. Once open, right-click on Local Area Connection and select Properties:Figure 8 – Network ConnectionsVersion 1.1 Getting Started with the Xilinx Spartan-6 LX9 MicroBoard 17
Page 1 and 2: Getting Started GuideVersion 1.1Xil
Page 5 and 6: Table of ContentsABOUT THIS GUIDE .
Page 7 and 8: ABOUT THIS GUIDEThis guide provides
Page 9: Installation and Licensing ofISE De
Page 12: Figure 3 - HyperTerminal - Setup Sc
Page 15: 3. The default factory test is comm
Page 19 and 20: 6. Click OK.7. Launch an internet b
Page 21 and 22: Next StepsAt the completion of this

Xilinx® Spartan®-6 FPGA LX9 MicroBoard

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?